Seismic Resistance / Trench / Bracket Production Equipment

Equipment Composition

Forming Line: Coiled material feeding and unwinding ---- Leveling and feeding unit ---- Main forming machine (toothed gear, marking) --- Calibration device --- Cutting system --- Receiving table; Electrical control utilizes PLC programmable logic control

Punching Line: Workbench -- Pneumatic Clamps, Servo Feeding Unit -- Hydraulic (Punch Press) Punching

Electrical control utilizes PLC programmable logic control

Punching method: Depending on actual conditions and considering a variety of factors, post-molding is utilized.

Customizable into an integrated punching and forming production line with pre-punching and then forming

Equipment Technical Conditions:

1. Equipment Footprint: 30×3.5×5 meters (Length×Width×Height)

1.2 Equipment Material Direction: TBA.

1.3 Voltage Parameters: 380V, 50Hz, 3-phase.

1.4 Gas Source: Flow rate of 0.5 m³/min; pressure of 0.6 MPa.

1.5 Hydraulic Oil: 46# Hydraulic Oil.

1.6 Gear Oil: 18# Hypoid Gear Oil.

2 Main Technical Parameters of Equipment

2.1 Rolling Strip Width: ≤300 mm

2.2 Rolling Strip Thickness: 2.0~2.5mm (Standard)

2.3 Rolling Strip Material: Q235

2.4 Production Speed: Continuous molding speed of the main unit is 0-15 meters per minute.

2.4 Rolling workpiece length: 2000-6000 mm

2.5 Total installed equipment capacity: approximately 50KW.

2.6齿深: ≥1.0mm