Proper use of feed machinery is closely linked to the quality and efficiency of feed production. In other words, correct operation can appropriately extend the service life of the feed machinery. As users, it is important to pay attention to the maintenance and care of the equipment during daily use to ensure safe production.

Firstly, to prevent any accidents during transportation and loading/unloading, it is mandatory to check for loose bolts and nuts, flat and round teeth, and the main shaft nut for any signs of looseness before use, and to tighten them promptly. Then, turn the belt pulley by hand to check for any collision issues. Pay attention to ensure the equipment can maintain smooth operation; if there is any debris inside, it must be cleaned thoroughly. Generally, it is required to run the equipment empty for a while first to confirm there are no abnormal issues before starting normal production.

Next, when operating feed machinery, it is crucial to maintain strict control over the cleanliness of materials. If any debris is found in the materials, it must be thoroughly cleaned out. It is strictly prohibited to allow items like iron blocks or stones into the machine to prevent damage and injury. Additionally, the receiving material bag should be at least 4 meters in length and 0.6 meters in diameter. The fabric should not be too dense, and it is important to empty the material promptly during use to ensure the bag has adequate breathability.

Thirdly, during the operation of feed machinery, strict control of feeding is also necessary. Ensure that the feeding is even and pay attention to the degree of the engine's load to avoid clogging. A pull-out plate regulator can be used to adjust the feeding amount when粉碎颗粒物. Note that when one corner wears down and affects work efficiency, turn the hammer blade over (turn all four groups at once to avoid unbalancing the rotor) and replace the hammer blade entirely.

In addition, it is essential to check lubrication and pre-add the appropriate amount of lubricant before each use of the feed machinery. After 500 hours of operation, the condition of the bearings should be inspected. When installing sieve plates, the burr side should be placed upwards. Select sieve plates with different diameters of sieve holes based on the fineness of the crushed material. Moreover, the rational design of the feed machinery and the selection of parameters must also ensure reasonableness.