KHJ0.1/12L Emergency Lockout Switch for Coal Mine Underground

KHJ0.1/12L Emergency Lockout Switch for Coal Mine Underground

I. Main Applications

The KHJ0.1/12L underground coal mine emergency interlock switch (hereinafter referred to as the interlock switch) is one of the main protective devices for belt conveyors and monorails, suitable for environments with explosive hazards such as coal dust in underground coal mines. It is connected to intrinsically safe system signal control in circuits that have passed intrinsically safe testing. In the event of various accidents along the conveyor line, operators can pull the rope along the line to activate the interlock switch, thereby cutting off power to the belt conveyor control system and stopping the machine. The interlock switch can also be used in non-explosive locations on the ground, such as steel mills, cement plants, power plants, ports, and docks, where belt conveyors are present, serving as an emergency interlock protection for rope pulling along the line.

Section II: Environmental Conditions for Use

The locking switch should operate reliably under the following conditions:

a. Environmental temperature: -10℃ to +40℃

b. Average relative humidity not exceeding 95% (+25°C)

c. Atmospheric Pressure: 80～106 KPa

d. Applications with no significant vibration or impact.

e. In environments where there is no severe condensation, waterlogging, or insulation damage from corrosive gases.

f. Working in environments with explosive mixtures of methane and coal dust underground in coal mines.

Section 3: Explosion-Proof Styles

Explosion-proof type and marking: Intrinsic safety type for mining, marking: Ex ibⅠMb

Section 4: Model Meanings

5. Dimensions, Weight, and Installation Sizes

a. Dimensions (Length x Width x Height): 490 mm x 180 mm x 78 mm

b. Weight: Approximately 4 kg.

c. Installation Dimensions: Fixed screw center distance is 226 mm ± 1 mm.

Six: Outline Drawing

Section 7: Technical Data

a. Force: 40-120N

b. Action Direction: Bidirectional action

c. Reset Force: ≤10N

d. Stroke Range: 8mm to 20mm

e. Rated Working Voltage: DC 12V, Maximum Working Current: ≤0.1A

f. Cable outer diameter: Φ10mm

g. Quantity of outlet bell mouths: 2 pieces (2 spare pieces)

h. Action Performance: Pulling any end wire rope of the locking switch, the locking switch should immediately respond to the action force and lock.

Warning signs are present indicating that the lock must be manually reset before it can be unlocked.