- AllProduct Category
-
化工储罐、填料塔系列
浓缩罐、提取罐系列
换热器、冷凝器系列
发酵罐、提取罐系列
反应釜、反应锅系列
干燥机、刮片机系列
短程蒸馏
离心式刮板薄膜蒸发器
刮板蒸发器、多效蒸发器
蒸馏塔
乙醇精馏塔
精馏塔
真空耙式干燥机


详情描述
Ethanol Distillation Tower

Ethanol rectification towers are suitable for alcohol recovery in industries such as food, light industry, and chemical engineering, helping to reduce production costs and enhance economic benefits. This unit can distill dilute alcohol, and for products with high concentration requirements, increasing the reflux ratio is possible, although this may decrease the yield. The effluent contains a reduced alcohol concentration, making it an ideal equipment for alcohol recovery. The device is equipped with two feed ports; low-concentration feed enters from the bottom port, while high-concentration feed enters from the top port. The lower the feed concentration, the higher the reflux ratio; conversely, the higher the feed concentration, the lower the reflux ratio.
Preparation before starting the ethanol distillation tower
(1) The product has undergone hydrostatic testing and trial operation before shipment, meeting the specifications as per the drawings.
(2) Test the waters.
(3) Carefully inspect all equipment, valves, and automatic control instruments in the entire distillation process according to the flowchart, ensure that check valves are not installed backwards, and correct any issues promptly.
(4) Operate the equipment individually to fill all pumps with oil, and promptly repair any issues found.
(5) Clear the site, dismantle installation and renovation scaffolding, remove debris, and ensure the operation area is clear and tidy.
(6) Calibration and marking of instruments and gauges.
(7) Notify production scheduling to supply water, electricity, steam, and compressed air on schedule as per the plan.
(8) Verify that the valves of the process pipeline, the drain valve, and the vent valve are in their normal positions.
(9) Inspect steam valves and cooling water gauges for proper operation, ensure pipelines are unobstructed, and check for any leaks.
(10) Verify that all valve doors are in the correct open/close positions, and only proceed with starting the machine after a double-check confirms correctness.










