Description

It includes both with and without graphite. The particle sizes range from 1.0mm to 1.5mm, 1.5mm to 2.0mm, and 2.0mm to 3.0mm. It melts and rapidly expands within the injection sleeve and at the top of the injection head, forming an excellent lubricating film inside the injection sleeve due to its capillary action. It is easy to use and does not require the traditional spray systems with drip-painting pumps used for oil-based or water-based products.

Appearance: White, yellow, transparent (not graphite), granular.

Application Range: Shot sleeve with diameter between 50-120mm; Black Granules: Containing graphite, spherical beads.
Density at 20℃: 0.5-0.7 cm³.
Application Range: Piercing sleeves with diameters ranging from 50 to 160 mm.

【Instructions for Use】

Add granules to the casting chamber using a particle emitter.
Usage volume for different punch diameters
60mm 0.4-0.5g
80mm 0.6-0.8g
100mm 1.0-1.3g
140mm 1.7-2.5g
150mm 2.2-4.0g
The determination of usage depends on the casting weight and requires experience-based trial and error.

【Advantages】

No contamination from general oily lubricants.
2. Reduce the occurrence rate of casting porosity.
3. Extends the service life of the plunger tube and reduces the adverse effects caused by friction.
4. The lifespan of the die-casting punch for factory use is generally doubled compared to using pure oil lubrication.
5. Increase jet speed.
6. Complete particle consumption during casting, with no lubricant contamination.
7. The castings have no oil stains on the surface, and are clean and shiny.
8. During the reclamation and reuse of gating, runner, and slabs, there are no oil stains, no smoke, and no air pollution.
9. No wastewater treatment required, no need for water cooling systems or cleaning injection nozzles.
10. Highly economical, saving on expenses.
11. Enhance process safety.