Electric Concrete Core Sample Planer HMP-150 Concrete Planer Double-End Planer for Concrete

Sales Phone: 189-0537-7135, Manager Li

The HMP-150 concrete core flattener is mainly used for flattening the ends of concrete cores.
Quickly flatten core samples with wet grinding, suitable for quality inspection and core sample flattening in construction engineering.

HMP-150 Concrete Grinding Machine
 Main Technical Parameters:
Grinding Concrete Core Sample Diameter (mm): 50, 70, 75, 100, 150
Grinding Concrete Core Sample Height (mm): 47.5 ~ 215MM
Milling Head Diameter: 160mm
End face跳动量：0.10mm
Rated Power: 1700W
Spindle Speed: 3400 rpm
Rated Voltage: 220V～
Input Power: 1700W
Packaging Dimensions: 630mm x 510mm x 750mm

Section 3: Instructions for Use
Plug in the power and water supply.
Select the appropriate fixture based on the core sample diameter, clamp the core sample tightly, and then tighten the fixture after positioning it to the center of the base.
Loosen the upper and lower tension handwheels, turn the lift handwheel, when the abrasive wheel face is at the same level as the core sample face.
Stop at 1mm. Then, tighten the upper handle, open the water inlet valve to allow water flow, and close the power switch to start the grinding wheel. Then, turn the handwheel counterclockwise while simultaneously turning the fine adjustment handwheel clockwise to lower the grinding head. When the grinding wheel face contacts the sample face, oscillate the grinding head for grinding until the sample face is flattened.
After grinding is complete, turn off the power and water nozzle valve, then rotate the micro handwheel counterclockwise to its uppermost position.
Loosen the clamp handle, remove the fixture with the sample and reverse-install it. Repeat steps 2, 3, and 4 to grind the opposite end face. Continue until the core sample end face meets the required specifications.

Turn off the power after using the grinder and wipe the machine clean.