One. Application
LT-901A ModelDigital Display Simply Supported Beam Impact Tester(5J) Used for the determination of impact toughness of non-metallic materials such as rigid plastic plates, pipes, special shapes, reinforced nylon, glass fiber reinforced plastics, ceramics, cast stone electrical insulating materials, etc.
Section 2: Specifications for Impact Beam Test Machine
Meets the requirements of GB/T1043 "Test Methods for Impact on Simply Supported Beams of Rigid Plastics" and ISO179, ISO9854-1, DIN8078, DIN53453, etc.
Section 3: Performance Features
Test results are fully digital displays.
2. Equipped with imported ball bearings, the pendulum process energy loss is reduced to a minimum.
3. Enter width and thickness test conditions, the system will automatically calculate the impact strength.
4. Digital Display Simple Beam Impact TesterUtilizing a 2500P/R import encoder for precise pendulum angle measurement.
5. Equipped with safety guards, ensuring the safety of the testing process.
Four. Simply Supported Beam Impact Tester Technical Parameters
Impact Speed: 2.9 m/s
Impact Energy: 1.0J, 2.0J, 4.0J, 5.0J
3. Swinging pendulum pre-tilt angle: 150°
4. Center Distance: 230mm
5. Impact Resistant Radius: R 0.5
6. Jaw Spacing: 40, 60, 62, 70
Power: AC 220V / 50Hz
8. Dimensions: approx. 550mm x 300mm x 900mm
Net Weight: Approximately 120 Kg
10. Standard sample dimensions are listed in the table below:
Sample Type | Length: l (mm) | Width: b (mm) | Thickness: d (mm) | Center to Center Distance of Supports L (mm) |
1 | 80±2 | 10±0.5 | 4±0.2 | 60 |
2 | 50±1 | 6±0.2 | 4±0.2 | 40 |
3 | 120±2 | 15±0.5 | 10±0.5 | 70 |
4 | 125±2 | 13±0.5 | 13±0.5 | 95 |
5 | 80±2 | 10±0.2 | (2.5) | 62 |
