Rebar Concrete Wall Cutting Machine, Window and Door Cutting Machine, Building Renovation Wall Grooving Machine
The wall cutting machine is primarily used for building renovations, reinforcement, and design changes, capable of cutting large areas of walls such as door openings, windows, and elevator shafts. It features manual feeding and cutting. The structure is damage-free and forms in one go, not only avoiding the structural damage caused by traditional hammering construction but also saving time, materials, and labor in drilling circular排孔. Additionally, it significantly reduces the time and costs associated with adjustments.
Main Technical Parameters:
Saw blades:800mm Cut Depth: 32cm
Power Voltage:220V, Power: 6200W
Dimensions:100*100*80cm
Product Actual Photo Display
Wall cutting machine operation instructions:
Secure the track with expansion bolts, place the machine on the track (the track has teeth, and the machine has gears that prevent sliding; movement is manual via handwheels only), install the saw blade and protective guard. Once water and power are connected, operate the machine using the handwheels: the middle handwheel controls the up and down movement of the saw blade, while the right-hand handwheel controls the machine's movement along the track.
Our wall cutting machines feature heavy-duty dual-insulated high-power motors and reducers, with low failure rates, long service life, and cost savings on maintenance. Mechanical clutch protector, effectively preventing damage to the machine and personnel due to improper operation. Equipped with manual or automatic cutting control, it not only improves construction quality but also accelerates the construction speed, while significantly reducing the labor intensity of the operator.
Machine Installation
First, install the track, then place the machine on the track.To achieve horizontal wall cutting, the correct installation of the track is: the motor should face up and the blade should face down. When cutting, the rotation direction of the blade should be as opposite to the motor's running direction as possible. This not only reduces the cutting time but also improves the cutting efficiency.
1. First, drill a hole with a hammer drill at approximately 165mm from the self-cutting position, creating a fixed hole for a 16.3-16.5mm diameter expansion bolt with a depth of 55mm. This hole can only accommodate one M12 expansion bolt included with the machine. The track can be installed and used in any direction around the hole.
2. Clean out the small debris inside the holes with a pneumatic gun.
3. Insert an M12 expansion screw into the machine, then use a mallet to tap it into the expansion screw hole, and hammer it to secure the screw.Ensure the expansion bolts are securely fastened in the holes; otherwise, the machine may shift or fall off during operation. Use the expansion bolts and threaded rods provided with the machine, and determine the number of expansion bolts based on the softness of the cutting surface. Track Secure firmly.
