(M3325) Eco-friendly Dust Extraction Sanding Wheel Machine, Dust Extraction Sanding Wheel Machine, Belt Drive Vertical Sanding Wheel Machine

1.The grinding wheel machine must rotate in the correct direction, allowing the chips to fly away from the wheel downwards only. 2After the grinding wheel machine is started, grinding should only be performed once the machine has stabilized. If the machine is跳动明显, stop and adjust immediately.3The abrasive wheel machine bracket and abrasive wheel should be kept3mmDistance, to prevent workpieces from piercing and causing accidents.4When grinding, stand on the side of the grinding wheel machine and avoid excessive force.5Select a grinding wheel that matches the spindle speed of the grinding machine according to the instructions provided.6New grinding wheels must have a factory certification or inspection/test mark. Do not use the wheel if any defects such as quality, hardness, grain size, or cracks are found before installation.7When installing the grinding wheel, the clearance between the inner hole of the grinding wheel and the main shaft should not be too tight. It should be adjusted according to the technical requirements for loose fit, generally controlled at0.05?/FONT>0.10Within millimeters.8The grinding wheel must be fitted with flanges on both sides, with a diameter not less than one-third of the grinding wheel's diameter. A gasket should be properly placed between the grinding wheel and the flange.9When tightening the bolt, use a specialized wrench; do not overtighten, and strictly avoid using a hard object to hammer it, to prevent the grinding wheel from cracking.10After the grinding wheel is installed, the protective cover,挡板, and bracket should be attached. The gap between the挡板and bracket and the grinding wheel should be maintained at>3Within millimeters, and slightly below the center of the grinding wheel.11Do not rush when starting a new grinding wheel; first, make a trial run to check.5?/FONT>10After a minute of trial rotation, it is ready for use.12Do not apply excessive force during initial grinding to prevent uneven distribution of force on the grinding wheel, which may cause an accident.13No grinding of materials like bronze, lead, wood, etc., to prevent wheel clogging.14While sharpening, the person should stand to the side of the grinding wheel, and it is not allowed for two people to sharpen on the same wheel simultaneously.15Longer sharpening time knives should be cooled promptly to prevent burning hands.16Regularly adjust the balance of the abrasive wheel surface to maintain good condition.17Grinders should wear protective eyewear.