Gap Flow Sedimentation System Design Scheme
Specific configuration
1. Settling WindowDimensions:3000Long×500High×6Sewing Width
Subject matter45#Stainless steel electroplated and spray-painted, with an organic glass center featuring etched measurements, model0.5m-0.7m/Instant
2.AgitatorAppliance：150L Power Supply:380V Speed Control Stirrer
A bypass valve is designed at the bottom of the stirrer, and it is used for emptying after cleaning. The instrument is equipped with a level gauge on the main body, allowing for real-time monitoring of the liquid level changes.
3.Flowmeter: Rotameter, used for calculating liquid recovery and flow rate, installed at the model's inlet.Model No.GYG-25Sample Turbine Flow Meter
Flowmeter, Turbine Flowmeter, Instrument Accuracy0.5%IP Rating;IP65
4.Differential Pressure Sensor: Used for calculating the pressure difference and frictional resistance before and after the fluid. Our unit designs three pipes for measuring frictional resistance, with inner holes of6mm/12mm/25mmCan be replaced on the same flange,Ranges are:1Mpa,10Kpa.All internal holes are polished.
5.Granular mud pump;For transmission of water, slurry, and sandFlow rate of the pump is per hour10Cube
6.Pipe valves;Fittings include high-pressure hoses,Ø85mmStainless steel pipe, valves availableØ85mmSluice typeValveMaterial is:304Stainless Steel 。Origin: Shanghai
7.Panel control box: Aluminum alloy stand with casters for easy mobility.
The instrument380V、220VWire classificationConfiguration of strong and weak circuits, aluminum profile bracket304Brushed stainless steel panels, high-strength mobile castersThe ground is fully covered with stainless steel line channel protective panels, ensuring the safety of the operators.
8.Frequency Converter: Used for slurry pumpWith the mixerSpeed controlFacilitates thorough blending and transmission of sand particles and liquids.
