Welcome cable recycling nationwide! On-site collection for scrap cable recycling, call us now. No middlemen, direct factory recycling, high prices, 24-hour collection, looking forward to your call! We offer top prices for all types of scrap cables, including power cables, communication cables, marine cables, mining cables, high-voltage cables, control cables, and stock cables. Welcome units and individuals with scrap cable wire to contact and negotiate recycling matters. We provide scrap wire and cable recycling and dismantling services!

Cable recycling methods and introduction:
Section 1: Mechanical Crushing and Sorting Method
Mechanical crushing method primarily consists of two units: crushing and separation. Waste cables are broken down into particles of specific sizes by the crushing unit, followed by the separation unit to segregate copper and plastic, resulting in pure copper and plastic.
Waste cables are conveyed by a feeding belt to a primary crusher (triangular blade crusher). The primary crushing products are magnetically separated to a separator screen, where larger particles are fed to copper rice making machine 1, and smaller ones to copper rice making machine 2. The crushed materials are then spirally conveyed to a vibrating screen, with a blower located at the bottom of the screen.
The material is separated into four components by wind vibration: copper rice and plastic are collected separately, while the uncrushed particles and the mixture of copper rice and plastic are returned to the respective stages for recycling crushing and separation.

剥线法: Strip Wire Method
This method is widely used in factories for the disassembly of large-diameter cables. The working principle of the automatic stripping machine is as shown in the figure below: The right roller stepper motor drives the upper and lower right rollers to move the clamped cable left and right; the cutting blade stepper motor drives the upper and lower cutting blades to move in opposite directions. By controlling the displacement between the upper and lower cutting blades, the stripping and cutting functions are achieved.
The left roller stepper motor drives the upper and lower left rollers to move the clamped workpiece line left and right; the twisting roller stepper motor drives the upper and lower left rollers to move forward and backward in the opposite direction, achieving the twisting function. The twisting roller and the left roller refer to the same roller physically.
This method exhibits good effectiveness in disassembling cables with large diameters. However, due to its reliance on manual labor, it has low production efficiency for cables with medium to small diameters, lacks automation, and has poor sorting capabilities for different cable types.

Section 3: Incineration Method
Incineration typically utilizes the flammability of plastic in wires and cables to recover the metal by burning. This is an early, primitive method of metal recovery that has been phased out!
The recycling of cables involves using specific techniques to separate the conductors from the sheath, followed by sorting technology to segregate the conductors from the sheath, resulting in relatively pure metals and plastics, thereby achieving resource utilization.