Company welcomes cable recycling nationwide. On-site collection for waste cable recycling, direct to factory recycling, high prices, 24/7 collection, looking forward to your call! We offer top prices for all types of waste cables, cable wires, power cables, communication cables, marine cables, mining cables, high-voltage cables, control cables, and stock cables, etc. Welcome businesses and individuals with waste cable wires to contact us for recycling negotiations. We provide waste cable wire recycling and dismantling services!

Cable recycling methods and introduction:
Section 1: Mechanical Crushing and Sorting Method
The mechanical crushing method primarily consists of two units: crushing and sorting. Waste cables are broken down into particles of a certain size by the crushing unit, and then sorted by the sorting unit to separate copper from plastic, resulting in pure copper and plastic.
The waste cables are conveyed to the primary crusher (triangular knife type) via a feeding belt. The primary crushing products are then magnetically separated to a separator screen. The larger particles are fed to copper rice crusher 1, and the smaller ones to copper rice crusher 2. After crushing, the material is transported by a spiral to a vibrating screen, with a blower at the bottom of the screen.
Materials are separated into four components by wind vibration: copper beads and plastic are collected separately, while the uncrushed particles and mixed copper beads with plastic are returned to the corresponding stages for recycling crushing and separation.

剥线法: Strip Wire Method
This method is widely used in factories for the disassembly of large-diameter cables. The working principle of the automatic stripping machine is as shown in the diagram below: The right roller stepper motor drives the upper and lower right rollers to move the clamped cable left and right; the cutting blade stepper motor drives the upper and lower cutting blades to move in opposite directions, and by controlling the displacement between the upper and lower cutting blades, the stripping and cutting functions are achieved.
The left roller stepper motor drives the top and bottom left rollers to move the clamped workpiece line left and right; the twisting roller stepper motor drives the top and bottom left rollers to move forward and backward in the opposite direction, achieving the twisting function. The twisting roller and the left roller refer to the same roller physically.
This method offers good effectiveness for dismantling large-diameter cables. However, due to its heavy reliance on manual labor, it has low production efficiency for cables with medium to small diameters, poor automation, and limited cable type sorting capabilities.

Section 3: Incineration Method
Incineration typically utilizes the flammability of the plastic in wires and cables to recover the metal by burning. This is an early, primitive method of metal recovery that has been phased out!
The cable recycling process involves using specific techniques to separate the conductor from the sheath, followed by sorting technologies to segregate the conductor from the sheath, resulting in purer metals and plastics, thereby achieving resource recovery.