Utilizing high iodine value activated carbon powder, pressure molded with molding adhesive, and then sintered at high temperatures. This product features a cubic structure with uniformly distributed voids, suitable for gas treatment, commonly used for low concentration gas treatment.

Honeycomb activated carbon is made from coal-based activated carbon, formed by honeycomb-shaped molds and then activated through high-temperature sintering. It can be used in various gas purification equipment and waste gas treatment projects.

Honeycomb activated carbon can be used directly or placed in a purification cabinet or adsorption bed. If the exhaust gas concentration is high and the volume is large, two purification cabinets and adsorption beds can be alternated for use. During operation, avoid excessive temperatures as high temperatures will reduce the adsorption capacity, which decreases with increasing temperature; also, avoid high dust and oil mist as asphalt dust mist can block the micropores of the activated carbon, increase resistance, and decrease adsorption efficiency. If the operating environment contains a large amount of dense dust and asphalt, a pre-dust filter should be installed to achieve good performance and a longer service life.

Honeycomb activated carbon, after water-resistant treatment and secondary firing, boasts high strength, water resistance, acid resistance, and strong alkali resistance. It is suitable for wastewater treatment, organic solvent recovery, and adsorption, and can serve as a carrier for various catalysts.