Wall breaker, Wall cutting machine, Reinforced concrete door and window opening machine

Wall Cutting MachineZX-800

Voltage:220V-
Frequency:50-60Hz
Power:6680W
Using saw blades:12〞-32〞，300mm-800mm
Cutting Depth: 320MM, suitable for cutting or grooving reinforced concrete walls, brick walls, or stone materials, etc.

Wall saws are primarily used for building or old structure renovations, reinforcement, and design alterations, capable of cutting through large areas of walls such as door and window openings or elevator shafts.AnyuanThe wall cutting machine maintains structural integrity with a single molding process. This not only avoids damage to the building structure from traditional hammering construction methods, but also saves on time, materials, and labor associated with drilling circular holes. The wall cutting machine is a crucial piece of equipment in concrete production, directly affecting the process, layout, and dimensions of the product line. Our wall cutting machine offers stable technology. Superior performance, highly praised by our dedicated customers. Shipped to  各地的 customers are becoming users of concrete block production lines.Helper。

Concrete Reinforcement Cutting Wall MachineMachine Installation

First, install the traveling track, then place the machine on the track.To facilitate horizontal wall cutting, the correct installation of the track is: the motor should face up and the blade should face down. During cutting, the rotation direction of the blade should be as opposite to the motor's running direction as possible, which not only reduces the cutting time but also improves the cutting efficiency.

1. First, drill a hole for a膨胀 bolt at approximately 165mm from the initial cutoff point with a soil drill, with a diameter of 16.3-16.5mm and a depth of 55mm. This hole is designed to fit only one M12 expansion bolt included with the machine. The track can be installed and used in any direction around this hole.

2. Clean out the small debris inside the holes with an air gun.

3. Insert the M12 expansion screw provided with the machine, then tap the screw into the expansion screw hole with a mallet, and hammer it to secure the expansion screw.  Ensure the expansion bolts are securely fastened in the holes; otherwise, the machine may move or fall off during operation. Use the expansion bolts and threaded rods provided with this machine, and determine the number of expansion bolts based on the softness of the cutting surface. Track Secure firmly.

4. When installing the main unit, align it according to the forward arrow on the unit. Connect the speed controller and the plug in sequence, then turn the handwheel counterclockwise to move the main unit along the track.

5. Insert the saw blade; the inner diameter of the main unit is 35mm. Hexagon screws for securing the saw blade  Open-end wrench  Securely lock.

6. Align the saw blade with the cutting line and position the track for advancement.  Adjust the horizontal adjustment screws on the six hexagonal heads on the travel track with a hex wrench, moving them up and down to level the track. This prevents the travel rail from derailing at the joint.