Wall Cutting Saw Blade, Wall Cutting Machine, Door and Window Floor Cutting Machine

First, drill a hole with a hammer drill at a position approximately 165mm from the self-separating cut, with a diameter of 16.3-16.5mm and a depth of 55mm for the expansion bolt. This hole can only accommodate one M12 expansion bolt included with the machine. The track can be installed and used in any direction around the hole.

2. Clean out the small debris inside the holes with a blow gun.

3. Insert the M12 expansion screw provided with the machine, then tap a mallet into the expansion screw hole, and hammer it to secure the expansion screw.  Ensure that the expansion bolts are securely fastened in the holes; otherwise, the machine may move or fall off during operation. Use the expansion bolts and screws, as well as the fixed guide rails provided with this machine, and determine the number of expansion bolts based on the softness of the cutting surface. Track Secure firmly.

4. When installing the main unit, align it with the forward arrow on the unit, connect the speed controller and the power outlet in sequence, then turn the handwheel counterclockwise. The main unit will move along the track.

5. Insert the blade, the inner hole of the main unit is 35mm. Six-point screws for securing the blade  Open-end wrench  Tighten.

6. Align the saw blade with the cutting line and guide the track.  Adjust the six hex nuts with a hex wrench to move the six level adjustment screws up and down on the moving track, to align the level, preventing the moving rail from derailing at the connection point.

Accessories:Two 1.2-meter aluminum runway poles, waterproof covers.  One saw blade, suitable for cutting or grooving reinforced concrete walls, brick walls, or stone materials, etc. Semi-automatic (multi-)1 walking motor and control box, track movement forward and backward is automatic, knife insertion is manual). Fully automatic (includes 1 additional walking motor and 1 knife insertion motor, 1 control box. Can move automatically, insert knife automatically).

Voltage220V, Frequency: 50-60Hz
Power: Model 8006680w (800 blades installed, cuts up to 320mm)
Model 10007500w (contains 1000 saw blades, cutting diameter 420mm)
1200 Model7680w(1200 blades installed, cutting 520mm)