Automatic Wall Cutting Machine AY-800 Wall Saw Reinforced Concrete Cutting Machine

· 

Model                            ZX-800         ZX-1000       

· 

Frequency/HZ                       50-60          50-60          

· 

Saw blade/mm                      800            1000           

· 

Voltage/V                      220            220             

· 

Power/W                6880         7180        

· 

Cutting Depth/mm    320         420            

· 

Weight/KG                50             80              

· 

Dimensions/M                         1.0*1.0*0.8       1.2*1.2*0.8     

· 

· 

Wall saw/The wall cutting machine is primarily used for building renovations, reinforcement, design changes, etc., capable of cutting through large areas of walls such as door openings, windows, and elevator shafts. It features manual feeding and cutting. The structure is damage-free and forms in one go, not only avoiding the damage to building structures caused by traditional hammering construction but also saving time, materials, and labor compared to drilling circular排孔 methods.

Concrete Reinforcement Cutting Wall MachineMachine Installation

First, install the track, then place the machine on the track.To ensure horizontal cutting of walls, the correct installation of the track is: the motor should face up and the blade should face down. When cutting, the rotation of the blade should be as opposite to the motor's running direction as possible. This not only reduces the cutting time but also improves the cutting efficiency.

1. First, drill a hole for an expansion bolt with a diameter of 16.3-16.5mm and a depth of 55mm at a position about 165mm from the cutting point of the hammer drill. This hole can only accommodate one M12 expansion bolt included with the machine. The rail can be installed and used in any direction around the hole.

2. Clean out the small debris inside the holes with a pneumatic gun.

3. Insert the M12 expansion screw provided with the machine, then tap the screw into the expansion screw hole with a mallet, and hammer it to secure the expansion screw.  Ensure that the expansion bolts are securely fastened in the holes; otherwise, the machine may move or fall off during operation. Use the expansion bolts and screws, as well as the fixed guide rails provided with this machine, and determine the number of expansion bolts based on the softness of the cutting surface. Track Secure firmly。