Specialized non-standard equipment for manufacturing wave-tooth composite gaskets and metal toothed gaskets..It is specifically designed for the production and processing of wave-tooth composite gaskets and metal toothed gaskets..It's a new production process for manufacturing wave-tooth composite washers and metal toothed washers..In the past, the production of wave-tooth composite washers and metal tooth washers involved mounting specific fixture tools on a general-purpose lathe.,And there are many processing procedures.,Labor-intensive,Time-consuming,Wasteful of materials,Low raw material utilization rate,Excessive waste at the bottom.Especially in the production of larger diameter wave composite gaskets and metal toothed gaskets,Ordinary lathes cannot process,A large vertical lathe is required for the processing and production.,Higher processing difficulty.Additional processing fees that further increase production costs.And this equipment,Employed new production technology,Reduced the cost of producing wave tooth composite gaskets and metal toothed washers..

Key Technical Parameters:
Voltage:380V50HZ  Variable speed motor:0.75KW   RPM:0~1320Transfer/Please provide the Chinese content to be translated.
Cylinder diameter:40mm   Cylinder Stroke:100mm     Drive shaft wheel:100mm
Ring thickness:3mm      Scope of Processing:DN300The above
Note:Available for production and processing2mm,4mm,5mmThick-walled toothed metal ring.