Guangdong Foshan Da Niao Xiang Sealant Manufacturer - Quotation - Market Price Construction Process 1. Horizontal first, then vertical: Clean the tile gaps (place the utility knife flat; the blade is parallel to the edge of the tile; the blade is almost parallel to the ground) to create an indentation of about 0.8mm; the edges of the indentation should expose the tile edge; PS: Make sure the cross intersections are cleaned well; 2. Clean the dust inside the tile gaps: Use a vacuum cleaner or a broom to sweep it clean; ensure that there is no moisture, dust, or particles inside the tile gaps; 3. Remove the sealant of the corresponding color: Peel off the label from the bottom, attach it to the bottle of sealant, pull the ring open. Let the sealant stand on the ground, hold one nozzle of the sealant in your left hand with the pointed end facing down at the outlet, cover the hand holding the nozzle with a damp cloth, and tap the nozzle with your right hand to push it open the sealant outlet. (The purpose of covering with a cloth is to prevent the sealant from spraying out ---- there is pressure inside the can); or you can also directly poke open the sealant outlet with a pointed object. However, be careful to prevent the sealant from splashing on the wall, ceiling, or body; screw the nozzle onto the sealant outlet; insert the glue gun; prepare to apply the sealant; moisten the sides of the tile gaps with a damp cloth; but the inside of the tile gaps must be clean and dry (this detail must be paid attention to!!!) 4. Apply a line of sealant: For beginners, start with 20-50cm, and gradually increase the length as you become more skilled, then place the glue gun flat; place a collection board under the nozzle; 5. Smooth the sealant: (mainly use a water scraper; a sponge; fingers can also be used) PS: How to hold the water scraper; four fingers on top, the thumb under the water scraper, transfer the excess sealant scraped out by the water scraper to the sponge. Continue steps 3, 4, and 5 until all horizontal lines of sealant are smoothed; the sealant surface will solidify in about 20 minutes; after feeling that the sealant has solidified, you can do all the vertical lines; 6. Within half an hour: Wipe clean any remaining sealant on the sides of the tiles with a damp cloth; 7. After 24 hours; normal use. The above method is to wipe clean after the sealant has solidified for half an hour; there is another method on the internet, which is to clean the sealant directly after smoothing it out, mainly with the following steps: 1. First, prepare for the construction, handle the tile gaps, use a small shovel to scrape out an indentation of less than 2mm deep in the tile gaps, which not only facilitates the application of the sealant but also prevents excessive wear in the future by storing the sealant in this indentation. 2. Then use a small brush to sweep away the dirt scraped out. 3. After the preparation is done, you can start the sealant, use a small needle to pierce the opening of the sealant, then attach it to the glue gun, and apply it along the tile gap since the method of inserting the glue gun is simple. 4. Apply a line of tile gap sealant and immediately use a scraper to smooth it out. 5. The new sealant is quick-drying, so you need to clean it with a damp sponge within 10-15cm, otherwise, it will be difficult to clean. 6. After two hours of construction, the surface is completely cured, and the construction surface can be used normally after 24 hours.