Heater Roll Welding Machine Operation Instructions

1、 Working Voltage: Three-phaseAC380V +10% ，50Hz + 1%。

2、 Work Environment:No frost from 0 to 45°C, humidity ≤ 85% without condensation droplets.

3、 Maintenance: Add lubricating conductive grease per shift3 times; clean the water circulation filter daily; clean the water tank sediment every 3 days; change the water every 20 days; use pure water for cooling in summer and antifreeze fluid in winter; replace the transmission gear oil once a month; dust collection and cleaning daily.

4、 Operation Method: After selecting the processing specification, the welder automatically applies pressure, rotates, welds, and stops upon closing the foot pedal switch. To stop the operation, simply open the foot pedal switch, which will deactivate all actions.

5、 Work must be conducted with a spark protection device to prevent personal injury.

6、 Welding machines generate high temperatures, causing the conductive copper wheels to wear over time. If the copper wheels deform, accumulate weld slag, or need to be replaced, it should be corrected or replaced promptly during use.

7、 Cooling Machine Operating Voltage: Three-phase, four-wireAC380V + 10% ，50Hz + 1%。

8、 Chiller operating normally during operationPerform R134a refrigerant topping up every 3 months.

9、 Extended downtime, please drain the water from the water-cooled machine to ensure it remains dry.

10、 High Pressure Gauge Less Than2.6mpa。

11、 Low rolling gauge0.2mpa。

12、 In case of other emergencies, please shut off the power and contact the person in charge.