750V Surge Protection Device OD-V80B-750 Photovoltaic AC Side Low Voltage Surge Protector

750V Surge Protection Device OD-V80B-750, Low-Voltage Surge Protector for Photovoltaic AC Side

Power must be disconnected before installation, and live operations are strictly prohibited.

Recommend installing a fuse or an automatic circuit breaker in series at the front of the lightning protection module.

Please connect according to the installation diagram provided, with "+" indicating the positive wire, "-" the negative wire, and PE the ground wire. Do not connect incorrectly. After installation,

Close the automatic circuit breaker (fuse) switch and check if the working status is normal.

After installation, insert the module securely and check if the lightning protection module is functioning properly.

During the operation of the lightning protection module, it should be regularly inspected and the status of the fault display window checked. When the fault display window shows red (or for products with remote signaling, the corresponding indicator light is on),

When the remote signal terminal outputs an alarm signal, it indicates a fault in the lightning protection module, and it should be repaired or replaced promptly.

Surge protection modules for parallel power systems should be installed in parallel (the Kelvin wiring method can also be used). The connecting wires must be sturdy and reliable, and should be short and thick.

Direct.