To prevent such a terrible incident from occurring, how can we avoid the overflow of thermal oil in furnace? Below, let's understand it together based on common usage situations:
Oil temperature machine installation and operation instructions:
1. The rate of dehydration and temperature increase while driving is too fast, causing steam and low-boiling point volatile substances to impact and expand the bulge groove, leading to oil overflow. Solutions to avoid this: Strictly follow the temperature increase curve requirements for heating, and adjust the heating rate based on the pressure fluctuation and exhaust steam conditions.
2. Multiple thermal equipment units are used in replacement. When the high-temperature heat transfer oil rapidly flows into the low-temperature system and comes into contact with the cold oil, the cold oil absorbs heat and the low-boiling point components are vaporized and boiled; Solution: When the low-temperature thermal equipment is put into operation, the valves are gradually opened and gradually increased, allowing the heat exchange between the hot and cold oils to gradually balance.
3. Defects in the hot oil pump or oil leakage in the system. Solution: Loosen and continuously heat, loosen the drain valve to allow the heat-conducting oil to flow through the furnace tubes and into the low-level oil storage tank.
How to Safely Use an Oil Temperature Machine:
When selecting an oil temperature machine manufacturer, be sure to check if their products have the following safety protection features:
1. The system cannot initiate heating under no-pressure conditions, which prevents the heating tube from drying out and overheating.
2. Air disconnect function during startup, in case the over-temperature temperature controller detects the system temperature exceeding the equipment's designed temperature, it will disconnect the main power switch of the equipment to ensure that the equipment will not cause a fire safety accident due to high temperature.
3. Check if the equipment uses genuine accessories and if they meet the equipment's requirements. Avoid using substandard parts, as this can reduce the lifespan of the equipment and even lead to safety accidents.
Oil Temperature Machine Applications:
The oil temperature machine is suitable for producing engineering plastics and plastic products. It pre-adjusts to the required temperature for injection molds, forming the product in one go, thereby reducing trial mold materials. The mold temperature machine accurately reduces waste, providing production efficiency and quality, making it an indispensable tool in the injection molding industry.
Maintaining the oil temperature machine properly can prevent malfunctions and extend its service life; however, this requires that the machine itself be of high quality. Therefore, choosing a good oil temperature machine is also very important.
