Double-Curved Blender CAD Installation Drawing

GSJ-2500 Dual-Surface Blender Price

Double-curved mixer, submersible installation

Motor Power: 4 kW

Impeller Diameter: 2500mm

Shaft Material: SU304

Impeller Speed: 18 RPM

Installation Method: Bridge Mount

Duwan Environmental GSJ-2500 Double Curved BlenderTechnical Specifications

1、Dual-curvedMixers should be suitable for operation in raw water, sludge water, or medication mixture. During operation, there should be no fiber entanglement at any underwater location, ensuring uniform mixing in all areas of the pool, no sedimentation of sludge throughout the pool, no dead corners, and uniform mixing consistency.>95％。

2、Duwan Environmental ProtectionDetermine the mixer's output speed through calculation. The mixer must operate continuously under full immersion, intermittently, and after a long-term stoppage before resuming, maintaining smooth operation without vibration throughout the process.

3. The mixer should be capable of continuous operation for 24 hours a day.

4. The entire load of the mixer should be supported by the concrete bridge frame, with bearing supports at the bottom. It is driven through an overhanging vertical shaft and a gear reducer motor, with torque being transmitted by the gear reducer motor.

5. IfDouble-surface mixerBottom unsupported, impeller self-corrects during operation, ensuring downward force is vertical, preventing unbalanced movement.

6. The mixer impeller and motor rotation should match the pool type and flow state; even if a reverse occurs during operation, it will not cause any adverse effects on the equipment.

7. The transmission vertical shaft is connected and fixed to the output shaft of the reducer through a coupling. The transmission vertical shaft should have sufficient cross-sectional dimensions to bear all the working torques of the agitator impeller.

8. The gear reduction motor is mounted and securely fastened to the bridge架. The motor design must comply with IEC standards, and the rated power of the motor must be greater than the actual power.Please provide the Chinese content to be translated.High required power1.5x, F-grade insulation, 3P power supply, 380V, 50Hz, IP65 protection rating.

13.3.3 Electrical Requirements

The on-site electric control box is supplied as a complete set with the mixer. The power, control cables, and cable fasteners from the control box to the mixer are supplied by the equipment unit. See the electrical and control terms for technical requirements related to the control box and technology.

13.3.4 Self-control Requirements

Each mixer must achieve a single-step on-site control activation.The /stop function and with PLC remote control capability, the electrical control cabinet should be equipped with at least the following signal interfaces:

Input Signal (Passive Contact): Open/Stop Control Signal

Output Signal (Passive Contact): Manual/Automatic signaling;

                     Operation Signal

                     Comprehensive fault signal.

Passive contact signal logic: All signals are positive logic signals.

Signal Contact Capacity:220V，5A。