Epoxy patching mortar, for repairing damage.
Product Features
1. Features resistance to seepage, frost, salt, alkali, and mild acid corrosion.
2. The coefficient of thermal expansion is close to that of concrete, hence it is not easily detached from these bonded substrates.
4. Easy to operate and install, similar to conventional cement mortar work, easy to clean; water is sufficient for cleaning.
Product Application:
1. This epoxy mortar is suitable for repairing high-speed rail damage and also for leveling and smoothing surfaces.
2. Adhesive for acid-resistant bricks
3. Epoxy mortar is heat-resistant and can withstand high temperatures, suitable for repairing honeycomb, holes, and exposed reinforcement defects on the surface of concrete structures.
4. Underlay leveling is performed during steel bonding reinforcement and carbon fiber bonding reinforcement.
5. Epoxy mortar can be used as a corrosion-resistant material in corrosive environments such as seawater, saline-alkaline areas, and chemical factories.
6. Anti-erosion, anti-cavitation, and frost-thaw protection for the overflow surface of hydraulic structures, as well as repair after damage.
7. Protection and repair against acid, alkali, and salt corrosion for concrete or metal structures in chemical, petrochemical, industrial, and port facilities.
8. Abrasion-resistant protection and repair for road, bridge, airport runway, workshop, and other engineering locations; technical specifications
Inspection Items | Performance specifications | Test Results | |
Flexural strength (MPa) 28d | 6.0 | 6.49 | |
Compressive Strength (Mpa) | 7d | ---- | ≥25 |
28d | ＞30 | 35 | |
Neutralization Resistance (mm) 28d | ＜5.0 | 1.8 | |
Bond Strength (Mpa) | Room Temperature, 28 days | ＞1.0 | 2.8 |
Refrigerated/Heated Cycles 28d | ＞1.0 | 2.4 | |
Water Permeability (g) | ＜20 | 15 | |
24-hour Absorption Rate (g/m²)3） | ＜1000 | 525 | |
Water Absorption Coefficient (kg/cm)3•h0.5） | ＜0.5 | 0.32 | |
Note: Recommended usage: 1700kg/m3
Usage Instructions
1. Inspect the product packaging for integrity and ensure labels match correctly.
2. Open the drum lid and remove 3 pre-mixed bags labeled A, B, and C from within.
3. After shaking A material and B material evenly, pour them into separate buckets and stir well. Then, slowly add the "C" labeled powder while stirring, until it forms a uniform mortar consistency. If the mixture is too thick or difficult to stir evenly, add 1-2kg of clean water to this package and stir, which will not affect the final performance of the product.
Important Notes
1. This product is a cement-based material, requiring a full curing time of 28 days.
2. This product can proceed to the next step within 24 hours of use.
3. Mixed epoxy mortar should be used within 2 hours. If it becomes dry and thick within this time, add appropriate water, mix well, and then use it.
Packaging and Storage
1. This product is packaged in 20kg per drum, 100kg per set.
2. Unopened, the shelf life is 6 months; it must pass inspection and be deemed合格 before it can be used beyond that period.
3. This product is non-toxic, odorless, non-flammable, and non-explosive, meets green environmental protection requirements, and can be stored and transported as general cargo.
We hereby solemnly declare
The company assumes no liability for any losses resulting from improper use. Please follow the instructions in the manual for installation. For any issues, please consult your local dealer or our technical service department.
