Park decoration boat manufacturer custom-made in Guiyang, 4 meters in size

Main products include wooden boats, gondola wooden boats, small wooden boats, black-sail wooden boats, painting boats, catering boats, tourist boats, sightseeing boats, floating hotels, reception boats, and more; Exported to Japan, tourist painting boats, pointed wooden boats, electric wooden boats, motorized wooden boats, traditional Chinese craft wooden boats, decorated wooden boats; as well as various wooden boats and wooden boat models. 1. Chinese style series - Various Chinese replica ancient wooden boats: single-deck painting boats, double-deck painting boats, multi-layered deck boats, catering painting boats, single pavilion wooden boats, single canopy wooden boats, black-sail wooden boats, fishing boats, boats with high and low canopies, and more. 2. Varnish. 3. Oil for seasoning. 9. Launching. New boat oil should be left to dry for a period of time, wait for tung oil to dry completely before launching, the launching of a new boat is no less than laying a beam in building a house, the shipbuilders also wear red and green, and place golden flowers around their necks. Additionally, the wave plates are carved with auspicious characters, dragon eyes are carved, incense paper, candles, and incense sticks are burned, and firecrackers are set off to worship the Buddha. Wooden boats used for inland agriculture and fishing production are made of pure cedar, and large sea vessels used for coastal fishing production also use part of mulberry and elm trees as "dragon card" and "keel". The entire shipbuilding process employs pure manual labor. 2. Cutting and blending materials. The size of the cut materials depends on the hull structure. Generally, the hull is composed of the bow, middle section, and stern, made up of the hull bottom, sides, and transoms. The sizes of the boats vary, and the cut material sizes are quite particular. 3. Breaking boards. After cutting the round wood, it is then broken into boards. In the past, without electric saws, it was all done manually with a saw, first using a chalk line and a gage to mark the required thickness, then set up the board for sawing.