
Cautionary Notes
Ensure the following preparations are made when installing the automatic alignment machine:
Remove the stand leg of the upright roller from the base of the alignment roller bracket.
Remove the locating triangular iron from the alignment bracket.
3. The hand-pushed or pulled alignment bracket should be relatively loose; if the pivot shaft is rusty, it needs to be disassembled and rust removed.
4. The adjusting roller bracket should be elevated 20-40mm higher than the adjacent roller bracket and securely fastened.
5. A coal return section may occur below the belt, and a sweeper must be installed before the lower deviation corrector to prevent the coal return from damaging the corrector.























