Photovoltaic aluminum frame multi-pressure press LYA02-50 equipment specifications:

◆Forging process for photovoltaic module aluminum frames.

◆ Primarily used for the stamping of four installation holes, four ventilation holes, two drainage holes, grounding hole, and grounding marking on the long edges of photovoltaic frames, all completed in a single stamping process, significantly enhancing work efficiency.

◆ Also used for stamping processes such as photovoltaic short edge drainage holes and ventilation holes, completed in a single stamping, high efficiency, and good synchronization.

◆The machine can be equipped with multiple molds as per customer requirements, with the ability to move molds left and right, ensuring greater accuracy in the distance between the punch工艺孔 or installation holes.

Technical Specifications:

Power: 380V 50Hz (3-phase 4-wire system)

Power: 3.75 kW

Mounting Height: 180mm

Oil Pump Pressure: 16 Mpa

Fuel Tank Capacity: 30L

Nominal Pressure: 300 KN

Nominal Stroke: 15mm

Workbench Dimensions: 2200×200mm

Dimensions: (Length x Width x Height) 2400mm x 500mm x 1400mm

Weight: 1500 Kg