Product Details
One.Preface
DeaeratorBoilerOne of the key equipment in the heating system。
In the boiler feed water treatment process, deoxygenation is a very critical step. Oxygen is the primary corrosive substance in the feed water system and boiler. Oxygen in the feed water should be removed quickly, otherwise, it will corrode the boiler feed water system and components. The corrosion will produce iron oxide, which enters the pot, settle or adhere to the boiler tube walls and heating surfaces, forming difficult-to-dissolve iron scale that leads to poor heat transfer. Moreover, corrosion can cause pitting on the inner wall of the pipes, increasing the resistance coefficient. In severe cases of pipe corrosion, pipeline accidents may occur. The national regulations stipulate that the evaporation capacity is greater than or equal to2Steam boiler with a capacity of more than or equal to tons per hour and water temperature95℃All our hot water boilers are deoxygenated. Over the years, many boiler water treatments have been seeking a cost-effective deoxygenation method for ambient temperature water. Lianyungang Jiu Sheng Electric Power Auxiliary Equipment Co., Ltd. has years of experience in designing and manufacturing deoxygenators.JSNCYIntegral Series Oxygen Scavenger System(Also known as the new type internal oxygen remover, internal spray oxygen remover)Advanced design and manufacturing techniques are employed, offering numerous advantages over conventional deaerators in the industry. Several domestic companies, both established and under construction, have adopted the integrated deaerator technology, and all have achieved excellent operational results.
Two.Working Principle
The deaerator generally includes two working processes.:
1.One-time Deaeration: Water not yet deoxygenated enters the deaeration pipeline through the inlet, is ejected into a mist-like state via nozzles, and falls through the liquid-vapor mesh. It is then thoroughly mixed with steam entering through the steam inlet, achieving the deaeration temperature. Most of the oxygen in the water is released and expelled through the exhaust port, completing the one-time deaeration process.
2.Deaeration II: The purpose of secondary deaeration is to maintain the tank's temperature consistently at the deaeration level to maximize the deaeration effect. This process is achieved by heating the already deaerated water through the auxiliary heating port at the bottom, causing any oxygen not precipitated during the first deaeration to fully precipitate, significantly reducing the oxygen content in the water. At this point, the secondary deaeration is complete.
Three.Deoxygenator structure
JSNCYThe Series Type Integral Oxygen Remover is composed of a steam-water mixture heater, tank, soft water inlet coil, secondary heating and re-boiling tube, insulating board, cavitation prevention device, level gauge, thermometer, automatic overflow tank, safety valve, and electric valve.
Four.Deaerator Advantages
1.Steam and liquid mix instantly and uniformly, heat up rapidly, high thermal efficiency,Energy-efficient.
2.Carbonated beverage mixed heating steam pressure lower than,Suitable for use above the pressure of the heated liquid,And the steam pressure must be higher than the liquid pressure0.05～0.1MpaRestrictions.
3.JSNCYThe inline oxygen scavenger has minimal vibration and low noise.
4.JSNCYType-built-in oxygen-removing device, compact in size, Low investment.
5.JSNCYType internal deaerator, large temperature rise,Available100℃Above.
6.JSNCYType-inbuilt deaerator features a simple structure, easy to clean, maintenance-free, and long service life.
7.Utilizing low-pressure waste steam as a heat source for heating water saves energy and protects the environment.
8.Due to the selection of models based on user parameters or custom design, it offers good applicability to users, operates smoothly, and meets all user requirements.
Five.In-built Oxygen Remover Selection
Please provide the following information when placing an order:
1.Deoxygenator rated output
2.Water Tank Effective Volume
3.Work pressure
4.Operating Temperature
5.Inlet Water Temperature
