Product Details
One.Introduction
DeoxygenatorBoilerOne of the key equipment for the heating system。
In the boiler feed water treatment process, deoxygenation is a very critical step. Oxygen is a primary corrosive substance in both the feed water system and the boiler. Oxygen in the feed water should be removed quickly, otherwise, it will corrode the boiler's feed water system and components. The corrosion will produce ferric oxide, which can enter the boiler, settle or adhere to the boiler tube walls and heating surfaces, forming difficult-to-dissolve iron scales that lead to poor heat transfer. Moreover, corrosion can cause pitting on the inner walls of the pipes, increasing the resistance coefficient. In severe cases of pipe corrosion, even pipe accidents can occur. National regulations stipulate that the evaporation capacity is greater than or equal to2Steam boiler with a capacity of more than or equal to tons per hour and water temperature95℃All of our hot water boilers are deaerated. Over the years, numerous boiler water treatments have been seeking a cost-effective deaeration method for ambient water. Lianyungang Jiu Sheng Power Auxiliary Equipment Co., Ltd. has years of experience in designing and manufacturing deaerators.JSNCYIntegrated Type Series Oxygen Remover(Also known as the new type of built-in oxygen scavenger, built-in spray type oxygen scavenger)Utilizing cutting-edge design and manufacturing techniques, our oxygen removers offer numerous advantages over conventional industry models. Several domestic companies, both established and under construction, have adopted our internal oxygen removal technology, with all operational facilities achieving excellent performance results.
Two.Working Principle
The deaerator generally includes two working processes.:
1.One-time Deaeration: Water not deaerated enters the deaeration pipeline through the inlet, and is ejected as a mist through nozzles. The mist falls through the liquid-vapor mesh and thoroughly mixes with the steam entering through the steam inlet. This causes the misty water to reach the deaeration temperature, with most of the oxygen in the water being released and expelled through the exhaust outlet, thus completing the one-time deaeration.
2.Deoxygenation Stage 2: The purpose of the second deoxygenation stage is to maintain the tank's temperature at the deoxygenation level to maximize the deoxygenation effect. This is achieved by heating the deoxygenated water through the auxiliary heating port at the bottom, allowing any oxygen not removed in the first stage to fully precipitate, significantly reducing the oxygen content in the water. At this point, the second deoxygenation process is complete.
Three.Deoxygenator structure
JSNCYThe Type Series Integrated Oxygen Remover consists of components such as a steam-water mixture heater, tank, soft water inlet coil, secondary heating and reboiling tube, thermal insulation board, anti-foaming device, level gauge, thermometer, automatic overflow tank, safety valve, and electric valve.
Four.Deaerator Advantages
1.Steam and liquid instantly mix evenly, rapid heating, high thermal efficiency,Energy-saving.
2.Carbonated beverage mixed heating steam pressure below,Suitable for use above the pressure of the heated liquid,And not subject to steam pressure being higher than liquid pressure0.05～0.1MpaRestrictions.
3.JSNCYThe type integrated deaerator has minimal vibration and low noise.
4.JSNCYCompact integrated oxygen remover, Low investment required.
5.JSNCYType built-in oxygen scavenger temperature rise is large,Available100℃Above.
6.JSNCYType-in内置deoxygenator features a simple structure, anti-scaling, maintenance-free, and long service life.
7.Utilizing industrial low-pressure exhaust steam as a heat source to produce hot water saves energy and protects the environment.
8.Due to the selection of models based on user parameters or special design, it offers good suitability for users, operates smoothly, and meets all user requirements.
Five.Integral Oxygen Scavenger Selection
Please provide the following information when placing an order:
1.Deaerator rated output
2.Water Tank Effective Volume
3.Work pressure
4.Operating Temperature
5.Inlet Water Temperature
