The elevator safety doors are fully constructed of steel structures. The steel used meets national standard materials, and the manufacturing strictly follows the drawings, ensuring accurate dimensions and sturdy welds, achieving the purpose of safety protection. The elevator safety doors are lemon yellow, with the lower door sill panels featuring alternating yellow and black colors. These elevator safety doors are essential protective equipment for preventing personal injuries at construction sites and are suitable for various types of construction projects.

Elevator Safety Door Structure Introduction:

Door Frame

The door frames are typically made of Baosteel 20mm x 30mm square tubes welded together, and can also be custom made in 20x20, 25x25, 30x30, and 30x40 square tube sizes to meet customer requirements. Welded with argon arc welding, they offer high strength, stable quality, and are not easily de-welded when subjected to strong impacts or twists.

Door bolt

Latch features zinc-plated set latch, with an aesthetically pleasing design and ease of use. The latch is designed externally, accessible only by elevator operators to open and close the protective door, effectively preventing individuals waiting on the floors from opening it. This杜绝s the potential construction risks of high-rise object dropping and falling.

Front facade

The storefront is constructed using a combination of perforated steel mesh or welded wire mesh with steel plates. This design not only prevents waiting personnel from reaching through to open the door but also facilitates observation of the building by the elevator operators, enhancing communication between staff inside and outside the building. The high-strength cold-rolled steel plates are also commonly used in small cars, capable of withstanding impacts over 300kg. Additionally, the application of warning phrases and toe-guarding lines further enhances the civilized construction image of the site.

Door hinge

The hinge is made from a 16# round tube, greatly simplifying the installation process. Simply weld a 90-degree angle round bar to the corresponding position on the upright steel pipes of the outer frame, hang the protective door on it, and it's ready for use; disassembly is just as easy.