The training tower shall meet the following requirements:

One, the training tower should be located near the end of the training field with a reserved runway, and a 1.5-meter sand pit should be reserved in front of the tower.

The training tower should have at least four floors, and in cities with a high number of high-rise buildings, the number of floors may be appropriately increased.

Three. The training tower's facade windows on each floor must have no fewer than two windows, with a spacing width of 1.0 meter between them.

Four, the dimensions of the training tower window are 1.2m x 1.8m, the window must be no less than 0.65m from the tower edge, the window sill width is 0.35m, the sill plate thickness is 0.05m (protruding from the tower wall by 5cm), the height of each window sill from the floor of the same level is 0.8m, the height of each level is 3.5m, and an internal staircase with a clear width of no less than 0.7m should be provided, with a handrail tube diameter of no less than 0.026m.

Five, An unobstructed platform of at least 1.5 meters wide should be set on the inner side of each floor of the training tower, and a floor should be set on the top floor.

Six. It is advisable to set up an outdoor fire ladder in the training tower. The ladder should extend to the top of the tower and should ideally be set up at a height of 3 meters above the ground, with a width not less than 50 centimeters. Training Tower Description: 1. Mainly composed of (1) simulated windows, (2) floor partitions, (3) rear skeleton, (4) observation and command platform skeleton, and the main steel structural frame. Simulated windows are installed at the front of the tower (custom-made with a certain number of floors and windows as needed), with floor partitions (steel plates) between the upper and lower adjacent simulated windows. 2. A rear skeleton corresponding to the simulated windows is installed below the rear of the tower. 3. The simulated windows, floor partitions, rear skeleton, and main frame are bolted together. 4. Safety ladders connect between each floor. 5. The upper part of the tower is equipped with an observation and command platform.

Section 7: Training towers typically undergo anti-corrosion treatment with spray painting, in military green. Alternatively, camouflaged or galvanized.

Section 8: Our steel structure fire training towers are fully functional, featuring removable and installable designs with no limitations by region, terrain, or plot. They are constructed with assembly components, offering low cost and high recyclability, thus saving expenses and achieving twice the results with half the effort. Welcome all fire departments to order our fire training towers.