SB dual stage planetary gearbox

Liming reducer - SB series two-stage high-precision planetary reducer

Product advantages:

Low noise: below 74dB

Low backlash: accuracy within 9 arc minutes, can also choose 7 arc minutes, 5 arc minutes, or 3 arc minutes

Rate: Over 94%

High input speed: up to 6000RPM

High torque: higher torque than typical spur gear planetary reducers.

High stability: Made of high-strength alloy steel, the entire gear has undergone hardening treatment, not only surface hardening, ensuring a long service life and maintaining the initial precision even after long-term use.

High speed reduction ratio: Only modular design, planetary gearboxes can be connected to each other, and the speed ratio can reach 1/10000 or more.

Notes:

1. The reducer must be firmly installed on the machine to avoid any looseness or vibration.

2. Before installing the gearbox on the machine, it is necessary to confirm again whether the output shaft rotation direction of the gearbox is correct.

3. If the gearbox has been left in place for a period of time (4 to 6 months) before use, and the oil seal has not been immersed in lubricating oil or given proper protection measures, it is recommended to replace the oil seal, as it may have already adhered to the shaft and may even lose elasticity and cannot function normally.

4. Please try to avoid placing and installing the gearbox under strong sunlight or in extremely harsh environments. If possible, take protective measures for the gearbox to increase its service life.

5. Try to provide sufficient circulating air for the cooling fan of the motor to avoid affecting the efficiency of heat dissipation.

6. The standard working environment for reducers is from facility -25 ° to 45 °. If this range is exceeded, please contact the original factory technical personnel.

7. Various parts (pulleys, gears, couplings, shafts, etc.) must be installed on solid or hollow shafts with threaded holes or other tools to ensure correct installation without damaging all parts on the outer end of bearings or reducers, and lubricating oil should be used to lubricate the contact surface to avoid jamming or oxidation.

8. When starting, it is necessary to start gradually and not immediately increase the load. It should be gradually increased.

9. If any parts, items, or materials near the gearbox are damaged due to oil leakage, special protection or shielding should be installed.