Product Description: CE series aluminum alloy worm gear reducer is a new generation product developed on the basis of our original NE series. The body is made of aluminum alloy die-casting, with small volume, fast heat dissipation, non rusting surface, beautiful and durable. The worm is made of nickel chromium molybdenum alloy steel surface carburizing heat treatment and grinding, with smooth transmission, low noise, and high output torque. It can be installed freely.
Model: 30, 40, 50, 63, 75, 90
Speed ratio: 5, 10, 15, 20, 30, 40, 50, 60
Power: 40w-2.2kw
Product attributes:
Notes:
1. The reducer must be firmly installed on the machine to avoid any looseness or vibration.
2. Before installing the gearbox on the machine, it is necessary to confirm again whether the output shaft rotation direction of the gearbox is correct.
3. If the gearbox has been left in place for a period of time (4 to 6 months) before use, and the oil seal has not been immersed in lubricating oil or given proper protection measures, it is recommended to replace the oil seal, as it may have already adhered to the shaft and may even lose elasticity and cannot function normally.
4. Please try to avoid placing and installing the gearbox under strong sunlight or in extremely harsh environments. If possible, take protective measures for the gearbox to increase its service life.
5. Try to provide sufficient circulating air for the cooling fan of the motor to avoid affecting the efficiency of heat dissipation.
6. The standard working environment for reducers is from facility -25 ° to 45 °. If this range is exceeded, please contact the original factory technical personnel.
7. Various parts (pulleys, gears, couplings, shafts, etc.) must be installed on solid or hollow shafts using threaded holes or other tools to ensure correct installation without damaging all parts on the outer end of the bearing or reducer, and lubricating oil should be used to lubricate the contact surface to avoid jamming or oxidation.
8. When starting, it is necessary to start gradually and not immediately increase the load. It should be gradually increased.
