Ge Yao Electrical Energy Meter

The product employs an individual acquisition calculation method for each measurement channel, ensuring complete consistency and symmetry during use. It features various wiring methods, suitable for different load forms (for reference only below).

1. Voltage Input: The working voltage input should not exceed the rated input voltage of the product.100V or 400V, otherwise consider using a PT.

2. Current Input: Standard rated input current is5A, For conditions greater than 5A, an external CT should be used. If other instruments are connected to the CT, the wiring should be in series. Before removing the current input lead of the product, ensure to disconnect the CT's primary circuit or short-circuit it once.Secondary LoopRecommend using junction boxes; do not connect directly.CT for easy disassembly.

3. Ensure the input voltage and current correspond appropriately.Phase sequenceConsistency and alignment are essential; otherwise, errors in displayed values and symbols will occur!

4. Instrument input network configuration is based on the system'sCT ratio determines, in the case of 2 CTs, selectThree-phase three-wireTwo-component method; atWith 3 CTs, selectThree-phase four-wireThree-element method. Input network set in instrument wiring or programmingThe NET should match the wiring configuration of the load being measured; otherwise, it may cause the meter to measure incorrect voltage or power. In a three-phase, three-wire system,Voltage MeasurementWith the display ofLine VoltageIn a three-phase four-wire system, the voltage measurement shows:Phase Voltage。

Installation Dimensions: