详情描述

The Hot-Cleaning Furnace is a new type of specialized cleaning equipment designed for removing coatings from returned parts and fixtures on paint lines, widely used in industries such as air conditioners, refrigerators, microwave ovens, electric fans, computers, and home appliances, as well as motorcycles, bicycles, cars, steel furniture, telecommunications, and power transmission and transformation. It boasts comprehensive performance that meets standard levels. This equipment not only exhibits excellent environmental protection features but also offers significant economic benefits. After being inspected by environmental protection authorities, the emissions of SO2 and NO are only 1/10 of the national standard, and its operational cost is merely 1/8 of that of paint strippers.

 

I. Product Application

Remove continuously thickening coatings from spray fixtures and clamps without altering the mechanical properties of the fixtures.

2. Complete and thorough removal of不合格 paint or powder coating from the surface of metal components, without any damage to the workpiece.

3. Clean the paint layer adhered to the filter mesh and fan impeller of the water curtain cabinet.

4. Clean and remove winding and adhered organic matter from wires, cables, transformers, motors, and printing rollers.

5. Clean and remove grease, oil stains, and other organic substances from parts such as the engine, crankshaft, housing, piston rings, etc.

 

Section II: Specifications and Data

Cabinet: Heavy-duty steel plate steel structure, supported by square and channel steel. Full-welded construction with sealed contact to prevent fuel loss due to leakage.

Floor: Rigid refractory castable, thickness of 4"-5" (10-13cm), reinforced with steel I-beams. Easy to remove ash.

Door: Equipped with a snap-locking mechanism and high-strength sealing strip. The door can open over 180 degrees, ensuring safety and reliability, with ease of use and durability.

Explosion-proof: The unique gravity-sealed top automatically vents excess pressure, then closes to prevent air from contacting combustible materials.

Insulation on the adjacent walls, roof, and door: Covered with (10-15cm) 2-3 layers of lightweight ceramic fiber blanket for insulation, secured with stainless steel pins, stainless steel mesh plates, and locking washers without asbestos. Metal sleeve prevents mechanical injury to operators from the heat-insulating panel. Clean炉insulation rating: 2300°F (1275°C).

Exhaust:natural gas(Gas pressure requirement: 5-8KPa), or light diesel.

Power Supply: 220-250V, 50Hz, Single Phase, 5-10A

Water Supply: Minimum pressure 40 psi, maximum pressure 100 psi. Minimum flow rate 5 gpm (15 liters/min).

Normal Cycle: 3-5 hours (including cooling time) with automatic control.

Normal operating temperature: 750-800°F (400-430°C)

Pollution Standards: Compliant with the new environmental protection standards.

Safety and Health Standards: Compliant with the new OSHA standards. Meets NFPA 86 requirements.

Insurance Standards: Compliant with most national and local regulations.

Corrosion-Resistant Steam Barrier: Prevents corrosive steam from condensing in the furnace. Significantly extends the lifespan of the blast furnace.

Combustion Chamber Protection: Heavy-duty steel guardrails are installed around the upper and lower combustion chambers to prevent accidental or negligent impacts.

Multiple models of trolleys: Several different models of trolleys are available to meet your various load requirements (standard containers).

Gas Burner: Designed specifically for incinerators. Features include an excellent clog-free nozzle design, easy maintenance, and heavy-duty construction. The burner's automatic cooling system prevents nozzle damage.