详情描述

The Hot Cleaning Furnace is a new specialized equipment designed for cleaning paint return workpieces and fixtures on coating lines, widely used in industries such as air conditioners, refrigerators, microwave ovens, electric fans, computers, and home appliances, as well as in the motorcycle, bicycle, automobile, steel furniture, communication, and power transmission and transformation industries, achieving standard performance levels. This equipment not only boasts excellent environmental performance but also offers significant economic benefits. After inspection by the environmental protection department, the emissions of pollutants like SO2 and NO are only 1/10 of the national standard, and its operating cost is merely 1/8 of the paint remover.

 

I. Product Application

Remove the continuously thickening coating from the spray fixtures and clamps without altering the mechanical properties of the fixtures.

2. Complete and thorough removal of any non-compliant paint or powder coating from the surface of metal components, with no damage to the workpiece.

3. Clean the paint layer adhered to the filter mesh and fan impeller of the water curtain cabinet.

4. Clean and remove winding and adhered organic materials from wires, cables, transformers, motors, and printing rollers.

5. Clean and remove grease, oil, and other organic substances from parts such as the engine, crankshaft, housing, and piston rings.

 

II. Specifications and Data

Cabinet: Heavy-duty steel plate steel structure, supported by square and channel steel. Full-welded construction with sealed contact to prevent fuel loss due to leakage.

Floor: Rigid refractory castable, 4"-5" (10-13cm) thick, reinforced with steel structural channels. Easy to remove ash.

Door: Equipped with a snap-locking mechanism and high-strength sealing strips. The door can open over 180 degrees, ensuring safety and reliability with ease of use and durability.

Explosion-proof: Unique gravity-sealed top automatically releases excess pressure, then closes to prevent air from contacting combustible materials.

Adjacent Insulation: The furnace wall, roof, and door are covered with 2-3 layers of lightweight ceramic fiber blanket (10-15cm thick) and secured with stainless steel pins and mesh plates with stainless steel gaskets, asbestos-free. Metal sleeves prevent mechanical injury to operators from the heat-insulating panels. Cleanable furnace insulation rating up to 2300F (1275°C).

Exhaust:natural gas(Gas pressure requirement: 5-8 KPa), or light diesel.

Power Supply: 220-250V, 50Hz, Single Phase, 5-10A

Water Supply: Minimum pressure 40 psi, maximum pressure 100 psi. Minimum flow rate 5 gpm (15 liters/min).

Normal Cycle: 3-5 hours (including cooling time), automatic control.

Normal Cycle Temperature: 750-800°F (400-430°C)

Pollution Standards: Compliant with new environmental protection standards.

Safety and Health Standards: Compliant with the new OSHA standards. Meets NFPA 86 requirements.

Insurance Standards: Compliant with most national and local regulations.

Corrosion-Resistant Steam Barrier: Prevents corrosive steam from condensing in the furnace. Significantly extends the lifespan of the blast furnace.

Combustion chamber protection: Heavy-duty steel guardrails are installed around the upper and lower combustion chambers to prevent accidental or careless collisions.

Multiple model carts: Various models of carts can meet your diverse load requirements (standard containers).

Gas Burner: Designed specifically for incinerators. Features include an excellent clog-free nozzle design, easy maintenance, and heavy-duty construction. The automatic cooling system of the burner equipment suppresses nozzle damage.