详情描述

The Hot Cleaning Furnace is a new type of specialized equipment for cleaning paint return products and fixtures on painting lines, widely used in industries such as air conditioners, refrigerators, microwave ovens, electric fans, computers, and home appliances, as well as in motorcycle, bicycle, automotive, steel furniture, telecommunications, and power transmission industries, with comprehensive performance reaching standard levels. The equipment not only boasts excellent environmental protection features but also offers significant economic benefits. After being tested by environmental protection authorities, the emissions of SO2, NO, and other waste gases are only 1/10 of the national standard, and its operating cost is only 1/8 of that of paint strippers.

 

I. Product Application

Remove continuously thickening coatings from spray fixtures and clamps without altering the mechanical properties of the fixtures.

2. Complete and thorough stripping of non-conforming paint or powder coating from the surface of metal components, without any damage to the workpiece.

3. Clean the paint layer adhered to the filter screen and fan impeller of the water curtain cabinet.

4. Clean and remove winding and adhered organic matter from wires, cables, transformers, motors, and printing rollers.

5. Clean and remove grease, oil stains, and other organic matter from engine parts such as the crankshaft, housing, piston rings, etc.

 

II. Specifications and Data

Cabinet: Heavy-duty steel plate steel structure, supported by square and channel steel. Full-welded construction with sealed contact to prevent fuel loss due to leakage.

Floor: Rigid refractory castable, 4"-5" (10-13cm) thick, reinforced with steel structural channels. Easy to remove ash.

Doors: Equipped with a snap-lock component and high-strength sealing strip. The door can open over 180 degrees, ensuring safety and reliability with convenience and durability.

Explosion-proof: Unique gravity-sealed top automatically releases excess pressure, then closes to prevent air from contacting flammable materials.

Adjacent Insulation: The furnace wall, roof, and door are covered with (10-15cm) 2-3 layers of lightweight ceramic fiber blanket insulation, secured with stainless steel pins, stainless steel mesh plates, and locking washers, free of asbestos. Metal bushes prevent mechanical injury to operators from the insulating panels. Cleanable furnace insulation rating up to 2300F (1275°C).

Exhaust:natural gas(Gas pressure requirement: 5-8KPa), or light diesel.

Power Supply: 220-250V, 50Hz, Single Phase, 5-10A

Water Supply: Minimum pressure 40 psi, maximum pressure 100 psi. Minimum flow rate 5 gpm (15 liters/minute).

Normal Cycle: 3-5 hours (including cooling time) with automatic control.

Normal Cycle Temperature: 750-800°F (400-430°C)

Pollution Standards: Compliant with new environmental protection standards.

Safety and Health Standards: Compliant with new OSHA standards. Meets NFPA 86 requirements.

Insurance Standards: Compliant with most national and local regulations.

Corrosion-Resistant Steam Barrier: Prevents corrosive steam from condensing in the furnace. Significantly extends the lifespan of the blast furnace.

Combustion chamber protection: Heavy-duty steel guards are installed around the upper and lower combustion chambers to prevent accidental or careless impacts.

Multiple model trolleys: Various models are available to meet your diverse load requirements (standard containers).

Gas Burner: Designed specifically for incinerators. Features include superior non-clogging nozzle design, easy maintenance, and heavy-duty construction. The automatic cooling system of the burner equipment suppresses nozzle damage.