One: The design of the energy-saving Chinese lamp installation plan should be in harmony with the surrounding geographical environment, emphasizing both uniqueness and close connection.
II. Selection of Chinese Lantern Peripherals and Geological Structures
The area above the Chinese lantern must be free of high-voltage power lines and any vegetation that could obstruct installation. Underground, there should be no drainage ditches or municipal drainage pipe cables. Additionally, ensure the wastewater pipeline at the installation site is unobstructed to prevent any remaining water.
Section 3: Basic Construction and Installation of Embedded Components
Once the installation address is confirmed, it is necessary to dig a pit and pour concrete ground pieces. Either pre-fabricated castings can be used or concrete can be cast on-site. When casting the concrete foundation on-site, it should be poured and vibrated simultaneously; before the pouring is completed, install the foot bolt embedment and灌浆 the foot bolts twice. Additionally, pay attention to the majority of road lamp foot bolt support systems to prevent damage to the foot bolts.
After casting, level the embedded components and smooth the concrete surface.
Before installing good basic embedment for concrete components, ensure flatness from two directions. Monitor flatness throughout the installation process, with deviations not exceeding 5 millimeters to ensure the flatness of road lighting.
The general curing period for on-site manufactured foundations is typically 2-5 days (determined by the construction crew based on the operational temperature during construction). Throughout the curing process, horizontal testing should be conducted on the upper surface of the subgrade engineering to ensure its flatness. If it does not meet the requirements, repairs should be made promptly.
Additionally, pay attention to the construction of lightning protection grounding lines for machinery and equipment during the installation of basic embedded parts, and design the wire joint resistors according to the reasonable location of installation.
Four, Assembly of the Chinese Lantern Installation
Before assembly, check the quantity and quality of each prefabricated component of the Chinese lamp to identify and address any issues in advance. Proposed installation steps are as follows:
First, assemble the sedan chair. Install the bend arm and lamp cover. Mount the engine cover. Then, assemble the entire lamp, first sliding the base to the bottom and ensuring not to scratch the lamp post. Next, fit the support (some manufacturers call it "up support"). Finally, install the sedan chair, followed by the light source, and connect the power lines. Pay attention to keep the light source lines tightly against the sedan chair walls to avoid casting shadows.
V. Installation of the Chinese Lantern Stands
After the Chinese lantern is installed, inspect the assembly quality and perform a lighting test to ensure it's functional before raising it. The road lighting installation must be straight and vertically divide the longitudinal centerline of the ground. The road lighting should be aligned on a line parallel to the longitudinal centerline of the ground.
During road lighting installation, all base foot screws should be securely fastened with flat washers and spring washers. After tightening, the露出螺帽 of the base foot screws should not be less than two threads. Engineering reinforcement measures must be taken for parts that will rotate due to air pressure.
Yunnan Walde Lighting Technology Co., Ltd. specializes in outdoor lighting projects, offering a wide range of products including landscape lights, Chinese lanterns, garden lights, tall street lights, ground lights, road lights, solar lights, lawn lights, stake lights, underwater lights, LED lights, wall lights, beacon lights, searchlights, factory lights, explosion-proof lights, emergency lights, traffic signal lights, flag poles, and more. As a professional manufacturer, we provide a full range of styles, direct from the factory, ensuring genuine quality and affordable prices. If you're in need of street lights or other lighting products, please feel free to call for detailed discussions!!
