How to Install a Ventilation Tower

Firstly, for the hoisting of roof ventilation structures, four threaded ropes should be tied, with the threaded loops twisted in the direction of high stress. To prevent air from rising or descending from a distance or high altitude, the louver wind should be eliminated to avoid danger.

Secondly, for roof ventilation buildings and general motors, the motor exports to the exterior air box of the housing. To facilitate user connections, M20 threaded holes are installed on one side of the grille door. Then, users can insert the wires into the air bolt holes and apply them with the insulated sleeve. If the user does not use the connection holes, bolts should be applied.

The foundation surface for the fan installation should be level, solid circular, with the fan foundation naturally sealed, without the need for additional subgrade work, and no excessive surface gaps or fan waterfalls are allowed. Tighten the bolts.

Fourth, during the installation of components in ventilated buildings, thoroughly inspect for any damage or loosening of the fan connectors, and correct any issues promptly. The impeller rotates in the same direction.