Introduction to the Operation of a Belt Vulcanizing Machine

Discussing the operation of a belt vulcanizing machine, first, tighten the bolts at the four corners of the vulcanizing machine evenly; on the original belt body surface on both sides of the completed带头, place three groups of four-layer gauze, ensuring the width is appropriate. Place them on the tightly fitted iron pad. The fixed length of the belt head on the flat vulcanizing machine should be 100mm longer than the joint length Ls on both longitudinal ends; cover with the upper heating plate and place the jacks. Install the cross beam and begin to apply pressure. Two people operate simultaneously, starting from one side and gradually applying pressure in sequence, then reversing the order to reach the designated pressure; when the heating plate temperature reaches 135°C, exhaust once and continue heating. When the heating plate temperature reaches 140°C, exhaust again, ensuring all condensate water in the vulcanizing machine is drained. When the heating plate temperature reaches 145°C, start calculating the vulcanizing time.