- AllProduct Category
-
矿用传感器
Torque Measurement
Settlement and Deformation Monitoring
Pressure, Temperature, Level (Material Level) Measurement
Recommended Products
详情描述
Torque sensor applications:
1. Torque and power output testing of rotating power equipment such as motors, engines, and internal combustion engines.
2. Torque and power testing for fans, pumps, gearboxes, and torque wrenches.
3. Torque and power measurement for railway locomotives, automobiles, tractors, aircraft, vessels, and mining machinery.
4. Torque and power detection for wastewater treatment systems.
5. Suitable for manufacturing viscometers.
6. Suitable for process and batch industries.
7. Suitable for use in laboratories, testing departments, and production monitoring as well as quality control.
Product Technical Specifications (e.g., for a Non-contacting Dynamic Torque Sensor)
Indicator Name | Parameter Specifications |
Range | 0.01,0.1,0.5,1,2,5，10，20，30，50，100, 200, 300,500Nm (optional) |
Power Supply | ±15V DC (suitable for frequency signal output), 24V DC (suitable for voltage or current signal output) |
Torque Signal | 5-15 kHz (amplitude 12V, zero at 10 kHz), 4-20 mA, 1-5 V, 0-10 V (optional) |
RPM Range | 0 to 1000, 3000, 6000, 8000 RPM (8000 units requiring bearing replacement) |
RPM signal | Standard products do not include speed measurement.60 pulses/rev fixed speed signal |
Precision | ±0.3%、±0.5% |
Annual stability | 0.25%/year |
Insulating Resistance | ≥2000MΩ(100VDC) |
Ambient Temperature | -20～60℃ |
Relative Humidity | 0～90%RH |
Overload capacity | 150% |
Product Packaging | 1 Dynamic Torque Sensor (with key), 1 User Manual, 1 Certificate of Compliance, 1 3-meter aviation plug cable. |
Torque Sensor Installation Precautions
1、 The sensor shaft installation should be concentric with the shaft being measured.Axiality less than0.05mm，Axial and radial forces < 10N. The housing is fixed with a soft connection.
2、 Relative humidity for sensor operation≤70%, to prevent oil, water, and other chemicals from corroding.
3、 Preheat the sensor with power for more than 30 minutes before use.
4、 Prior to formal measurement, the sensor must undergo at least one pre-torque test.
5、 Select sensor shaft and housing with stickersMLabel the end of the test piece.
6、 The shock torque load must not exceed 200%.·FS.
7、 The激励voltage must not exceed 15VDC.
8、 Sensor outputs are typically floating ground unless otherwise noted (i.e., input and output are not grounded together).
9、 The positive and negative terminals of the sensor power with the amplifier must not be reversed.
询价单
