Which is the best UV curing machine manufacturer for the Dongguan automotive interior parts industry?

Section 1: Key Technical Parameters of UV Machines for Automotive Interior Trim Industry

1. Dimensions (approx.): Length 5500mm x Height 1700mm (without motor height) x Width 1500mm; each feeding and discharging section is 1000mm long, the UV section is 1500mm long, and the discharging section is 3000mm long; front and rear adjustable baffles; adjustable feeding port height; inner width 1200mm, feeding height 300mm.

2. UV Light Source: Utilizing two 6KW and four 3KW UV light sources. Two 6KW halogen bulbs are installed at the top of the UV machine, with two 3KW bulbs on each side (equipped with step-up transformers, reflectors, bulbs, and capacitors). The addition of a UV mirror reflective device significantly enhances the efficiency of ultraviolet light usage by up to 35%. Each UV lamp can be controlled individually, featuring adjustable angle mechanisms that allow for left-right and up-down height adjustments (adjustable angle of 90 degrees). An adjustable UV lamp tube angle adjustment device is added, with旋扭handwheels for adjusting the height of the lamp tubes above the furnace lid, suitable for different specifications and multi-sided products. The total length of the 6KW bulbs is 660mm with an effective light distance of 500mm and a wavelength of 365nm; the total length of the 3KW bulbs is 420mm with an effective light distance of 260mm and a wavelength of 365nm. Each lamp tube is equipped with an automatic timer, allowing for real-time monitoring of the lamp usage time for convenient replacement. Each lamp set is independently fitted with imported quartz heat-insulating glass sheets to effectively prevent infrared heat radiation to the product, avoiding deformation due to excessive temperature.

3. Fixation Method: Flat Beam Illumination

4. Power Supply: Three-phase five-wire system, 380V, 50Hz; the operating panel and electrical box are located below the conveyor belt. Each light source set comes with an independent control switch, allowing for independent adjustment of the light source power, which can freely switch between two levels (75% or 100%). The box is equipped with a 6-set light source starting system (transformer, capacitor).

5. Total Power: 37KW

Section II: UV Oven Structure Characteristics for Automotive Interior Trim Industry

Exterior Material: Constructed with 2mm thick Q235 cold-rolled steel plate (excellent in strength, ductility, and welding properties) through bending and welding fabrication.

2. Surface Treatment: After surface grinding, polishing, and phosphatizing (which can enhance the corrosion resistance of metals and the adhesion of paint); high-temperature spray painting with large corrugated patterns, to prevent rust and corrosion. Color: "Computer Gray."

3. Furnace Base Frame: Constructed from 40*40*1.5mm square tubes, it maintains the load-bearing strength on all sides of the furnace, preventing deformation.

4. Sealant Materials: The sealing strips are made of "3M" Am水淀粉，which effectively blocks light and enhances the sealing performance.

Section 3: Environmental Conditions for UV Machines in the Automotive Interior Trim Industry

Operating Temperature: -5℃ to 40℃

2. Relative Humidity: ≤85% RH

Power: AC380V ± 10%, 50Hz, three-phase five-wire system.