Installation Method for European Flat Tile Roofing

Installation Method for European Flat Roofing Tiles

If design drawings are provided for roof tiles, construction shall be carried out according to the specifications in the drawings.

2. Roofs constructed with wooden structures should use tiles with a lath cross-sectional area of 20x20mm, and anti-corrosion treatment should be done before construction.

3. Concrete roof surfaces can utilize wooden battens or cement tiles. The size of the tiles should not exceed 25×25mm. The cement mortar plane for the roof should be constructed according to building specifications; the smaller the plane error, the better the effect of the roof tiles.

4. Multiform roof tiles will require cutting to fit certain shapes during installation.

Roof tiles should overhang by no more than 10mm and be bonded with 1:1 cement paste, but gaps should be left vertically. The tiles should be secured with safety nails on the side.

6. The spacing of the roof tiles should be measured according to the actual back size of the tiles. It should not be too long or too short to affect the construction.

During construction, it is prohibited for the cement slurry to adhere to the surface of the tiles. If it does, it should be wiped off immediately to avoid affecting the decorative effect.

8. We recommend a steeper roof pitch to avoid excessive flatness.

All tile nails and safety nails must be used in full, especially in typhoon-prone areas; stainless steel wire or copper wire may also be used as alternatives.

Reasons for Waxing European Flat Tiles During Construction:

European flat tiles have been used in the construction industry since ancient times, serving as an upgrade to asphalt shingles, offering a more three-dimensional and artistic appearance upon close inspection. Generally, when constructing with European flat tiles, manufacturers often recommend pre-waxing. However, consumers may not fully understand why waxing is necessary. The reasons are as follows:

European flat tile roofs have been favored by consumers since ancient times, but as the saying goes, there's no perfect tile. Those who have laid European flat tiles know how inconvenient it can be to maintain. A little attention and you'll notice they're prone to staining. To prevent this issue, the commonly used method is to wax the surface of European flat tiles.

The manufacturer uses a polishing process for the surface of the slate tiles. While the polished European flat tiles have a shiny appearance, they contain numerous pores which are prone to absorbing dirt. Waxing the European flat tiles provides better protection, preventing damage from foreign particles and friction during installation. More importantly, it fills the pores on the tile surface, preventing dust from clogging them, making daily cleaning easier. The waxed European flat tiles ensure good cleanliness in everyday life, reduce cleaning intensity, and maintain the tile surface's beauty over time. That's why the manufacturer recommends waxing!