Rapid Flash Dryer
Disc Continuous Dryer
Propeller Dryer | Sludge-Specific Dryer
Tubular auger dryer
Rotary Flash Dryer
Disk-Type Vacuum Dryer
Product Details
产品Price Negotiable
最小起订Quantity： 供货总Quantity：
Do you offer customization? |
|
Specs |
Comprehensive |
Shipment Time |
7 days |
Product Introduction: A spray dryer is a type of continuous atmospheric pressure dryer. It uses special equipment to spray the liquid into a mist, allowing it to come into contact with hot air and dry. It is used for drying liquids, suspensions, and viscous liquids that are heat-sensitive, such as milk, eggs, tannins, etc. It is also used for drying fuels, intermediates, soap powder, and inorganic salts, among others. A spray dryer is a type of continuous atmospheric pressure dryer. It uses special equipment to spray the liquid material into a mist, which then contacts hot air for drying. It is used for drying heat-sensitive liquids, suspensions, and viscous liquids such as milk, eggs, tannins, etc. It is also used for drying fuels, intermediates, soap powder, and inorganic salts. Principle of Spray Drying Machine: A spray dryer is a drying method that uses an atomizer to disperse the raw liquid into droplets and then dries the droplets using hot gases (air, nitrogen, or superheated steam) to obtain the product. The raw liquid for spray drying can be a solution, emulsion, suspension, or even a molten or paste-like substance. The dried product can be made into powder, granules, hollow spheres, or pellet-like forms as required. The atomizer that converts the liquid into droplets is a key component of the spray drying process. Safety Precautions for Spray Drying Machine: 1The drying cabinet should be placed in a dry indoor location for optimal use, and the outer shell must be properly grounded. 2In the power circuit of the laboratory small spray dryer, the user should install a switch with the current corresponding to the drying chamber for this box. 3Each drying cabinet comes with two adjustable shelf grids for arranging samples, and the spacing between the shelves can be adjusted according to the size of the samples. Samples should not be arranged too closely to ensure proper airflow. It is strictly prohibited to place samples on the bottom plate of the workroom to prevent damage due to overheating. 4This unit is a digital temperature controller. When setting the desired temperature, simply press the temperature setting button on the control panel to the required temperature and you can start the process. Product Specifications: Project/Parameters 5 25 50 150 200-2000 Inlet Temperature (°C) 140-350 Self-Control Export Temperature (°C) 80-90 Moisture Evaporation Rate 5 25 50 150 200-2000 Centrifugal spray head drive type Compressed Air Transmission Mechanical Transmission RPM (revolutions per minute) 25000 18000 18000 15000 8000-15000 Spray Disc Diameter (mm) 50 120 120 150 180-240 Heat source Electricity Steam + Electric Steam and electricity, fuel oil, gas, hot blast air Electrical Heating Power (kW) 9 36 72 99 Dimensions (m) 1.8×0.93×2.2 3×2.7×4.26 3.5×3.5×4.8 5.5×4.7 Determine as per actual circumstances Dry Powder Recovery (%) ≥95 Note: The amount of water vaporization is related to material characteristics, solid content, and the temperature of the hot air at the inlet and outlet. The data in the table is for reference only. Users can select the heating method based on local energy conditions and choose the dust collection method according to the material characteristics. 
Phone Consultation