Where can the special distribution of the fiber duct system be found?

Southwind Ductwork should only be installed after all civil engineering and other equipment installations are completed, ensuring the site is clean, especially with all sand, paint, polishing materials, and construction debris removed. Installation should follow a thorough cleaning of the room. During the installation process, ensure that workers' hands and tools are clean. Also, maintain the cleanliness of all tools and equipment that come into contact with the system piping to ensure a good appearance of the installed pipes.

The fiber fabric ductwork is determined by its unique polyester fiber material properties to be easy to install. Once the corresponding hanging steel wire or track is set up, the installation of the system is as simple as hanging curtains. Compared to the installation period of traditional ventilation systems, it can save up to 90% of the time, significantly highlighting its advantages in ease of installation for time-sensitive projects.

On-site inspection and measurement of the outlet heights and diameters of each galvanized steel duct, determining the specific length of the system with reference to the design drawings.

All supports securely installed. Requirements: The front and rear supports of the same pipe must be installed parallel and symmetrical, with no offset.

Manufacturing Wire Rope

The production of rope ends, rope length estimation (the length should be slightly longer than the actual required length, with a difference in length after cutting of ≤0.5m from the actual required size).

Installation of Wire Rope Hoist System

The Sling Bolt Fixation: When installing the wire rope suspension system, the sling bolt should be adjusted to the appropriate length to facilitate the adjustment of the rope's straightness after the system is installed for bearing.

The determination of the number and installation positioning of 2mm wire rope hangers: Use 2mm wire rope hangers when the suspended height between the wire rope and the top is greater than 1.6 meters. The number of quick hangers can be calculated at about one every 7 meters. The fixed points on the top plate during quick hanger installation should be on the same vertical plane as the wire rope. On-site fabrication of 2mm wire rope hangers (each end of an appropriately cut 2mm wire rope is fixed with a clamp).

Pipe segment suspension

South Pipeline Installation: Hang the pipe hangers in sequence according to the pipe numbering and pull up the intermediate and end couplings.

Entrance Installation: Fit the entrance, tie-wrap installation, riveting

During riveting, install at an interval of approximately 15 to 30 cm between each rivet.

During installation, it is required to pull the zipper between the pipes to ensure the correct installation angle of the entrance (an incorrect angle can cause the pipe at the entrance to twist and wrinkle).

Tighten the wreath bolt to straighten the steel rope.

The hanger behind the straightened pipe is securely fastened to the steel wire with a locking head.

During installation, ensure that the South system is not allowed to touch the ground; pull it out of the box and hang it up.

This concludes our explanation of fiber ducts by Nanjing Bangkefu Fiber Fabric Duct Co., Ltd. Should you need further information, please call our hotline or visit our website for updates.