Suzhou Processing Center Protective Cover Technical Data:

The machining center protective cover is made from high-quality 2-3mm thick cold-pressed steel plate, and can also be made of stainless steel upon request. The special surface polishing adds further value to it.

We offer corresponding guide rail protection types (horizontal, vertical, inclined, transverse) for all types of machine tools.

Our protective cover structures vary depending on the operating speed and guide rail. For speeds below 10m/min, we install polyamide or brass sliders.

Rollers are installed for speeds below 30m/min. Additionally, a cushioning system is required between the drive plate, chip scraper, and chip suction plate. The purpose of the slider cushioning system is to reduce collisions, noise, and friction.

Suzhou Processing Center Protective Cover Advantages:

1. Each shield can be triggered simultaneously, *differing from the conventional shields that are pulled one after another, thus producing extremely low noise.

2. The protective cover of the device can extend its service life.

3. Increases the shield's movement speed to 120m/min and withstands higher G-values (up to 2G).

4. Ensures the guard is in motion and parallel (avoiding the common drawback of snake-like movement in typical shear-type guards).

5. It operates more smoothly at high speeds without producing vibrations.