The gear magnetic particle inspection machine is a specialized testing device designed for magnetic particle inspection of gear tips, surfaces, and roots. Equipped with systems for magnetic suspension liquid spraying, recovery, filtration, and mixing, the entire machine's operation sequence and timing are controlled by an industrial programmable logic controller (PLC), enabling functions such as electrode rod clamping, material feeding, spray, magnetization, observation, and demagnetization. In terms of magnetization methods, the machine can achieve circumferential and longitudinal magnetization separately using the rod-insertion method and the magnetic yoke induction method, or can perform composite magnetization for all-around inspection in one go. Both circumferential and longitudinal magnetization offer phase control upon power failure.
Section II: Main Technical Parameters:
• Power Supply: Three-phase four-wire: 380V ±10% 50Hz
• Axial output current: AC 0-12000A (continuously adjustable with phase control for power interruption)
• Axial Output Flux: AC 0-20000AT (Continuous adjustable, with phase control upon power interruption)
• Demagnetization Method: Automatic Decaying Demagnetization
• Gas Source Pressure: 0.3—0.5 MPa
• Operation Modes: Automatic Operation and Manual Operation
• Magnetization Methods: Axial Magnetization, Longitudinal Magnetization, and Composite Magnetization
• Ultraviolet Light Intensity: The surface UV intensity of the workpiece at 38 cm from the lamp tube is greater than 1200 μW/cm²
• Demagnetization Effect: Residual Magnetism of Workpiece ≤ 0.3 mT (3Gs)
• Sensitivity: Type A 2# Sample 15/50 Clear Display
• Operating Environment: -20℃ to +40℃
• Relative Humidity: <90%
• Usage Conditions: Temperature 0℃ to +40℃