50-150MM Concrete Grinding Machine HMP-150 Core Sample Wet Leveler

Sales Phone: 189-0537-7135, Manager Li

The HMP-150 concrete core flattening machine is primarily used for flattening the ends of concrete cores.
Quickly flatten core samples with wet grinding, suitable for quality inspection and core sample flattening in construction engineering.

HMP-150 Concrete Grinding Machine
Main Technical Parameters:
Grinding Concrete Core Diameter (mm): 50, 70, 75, 100, 150
Grinding Concrete Core Sample Height (mm): 47.5~215MM
Head Diameter: 160mm
End face跳动量：0.10mm
Rated Power: 1700W
Spindle speed of grinder: 3400 rpm
Rated Voltage: 220V～
Input Power: 1700W
Packaging Dimensions: 630mm x 510mm x 750mm

Section 3: Instructions for Use
Plug in power and water supply.
Select the appropriate fixture based on the core diameter, clamp the core securely, and then tighten the fixture after positioning it at the center of the base.
Loosen the top and bottom tension handwheels, turn the lifting handwheel, when the abrasive wheel face is at a distance from the core sample face
Stop at 1mm. Then, tighten the upper handle, open the water inlet valve to allow water flow, and close the power switch to rotate the grinding wheel. Then, turn the handwheel counterclockwise while simultaneously turning the micro-handwheel clockwise to lower the grinding head. When the grinding wheel face contacts the sample face, oscillate the grinding head to grind until the sample face is level.
After grinding is complete, turn off the power and water nozzle valve, then turn the micrometer handwheel counterclockwise to the upper limit position.
Loosen the clamp handle, remove the clamp along with the sample and install it in reverse. Repeat steps 2, 3, and 4 to grind the opposite end face. Continue until the core sample end face meets the required specifications.

Turn off the power after using the grinder and wipe the machine clean.