The MS Type Embedded Auger Conveyor is designed strictly according to national industry standards, being standardized and systematic, with a wide range of applications.
·Transports materials with high bulk density, strong abrasiveness, and poor fluidity. Allows for multiple feeding and unloading points, flexible process layout, fully enclosed conveying, and environmental protection without pollution.
· MS Type BurialScraperConveyor Belt可采用 flat scraper blades, extending the head and middle discharge openings, adding a discharge impact device, and increasing the radius of the curved section arc, to eliminate head, tail, curved section, material accumulation, and blockage phenomena, or opt for a dedicated series scraper conveyor. The MS type buried scraper conveyor is suitable for:
The MS type auger conveyor is widely applicable to materials with bulk density ≤1.2t/m3, temperature below 100°C, and moisture content that forms into a ball when squeezed by hand but remains loosely sticky, such as powdered, granular, and small piece materials like coal fines, ash, grain, cement, etc.
·This MS type troughed belt conveyor is not suitable for transporting the following materials: materials with high bulk density (>1.2t/m3) that are abrasive and highly adhesive; materials that are fragile and prone to breakage in the process; corrosive materials; materials with good fluidity; materials that are high-temperature, flammable, or explosive.