GQ-150 Type Sewer Snake, Electric Pipe Cleaner, High-Pressure Clearing Equipment

Ideal for cleaning debris, grease, silt, and trash from the interiors of various pipelines.  Widely applicable to pipeline facilities in homes, offices, hotels, schools, and residential communities.

1. Local plug Insert single three-way socket.

2. On/off control knob on the unit.

"O" disengages stop; "L" reverses; "R" forwards

3. When installing a Φ16 flexible shaft, pull it out about 150mm. Insert it along with the accessories shaft into the shaft hole at the back of the machine. After pushing it flat, pull out the pin and rotate it to the left to engage the bracket using the positioning block at the end of the machine. Release the pin bolt, and it will spring into the Φ16 hole, completing the accessory installation.

4. Install the soft shaft and cutter head; align the T-slot and insert it relative to each other, then push the pin in and lock it. Once the pin pops out, the joint is secured.

5. During use, the machine should be kept aligned with the pipe end.  Maintain a distance similar to the height of the machine. Press down on the operating handle while holding the rotating flexible shaft, pushing and pulling to adjust its natural curve, and you can push it into the pipe opening.

  Operation Precautions

Before operation, check for any abnormalities in the machine; otherwise, stop using it.

2. To ensure operations  ， Use single pole three-prong plugs and outlets with good grounding.

3. If the insulation resistance of the machine is less than 2MΩ, it should be suspended for use. It should be dried and ventilated, and may be used again only when the insulation resistance exceeds 2MΩ.