
Product Introduction
The JLM.JLK series of wood-specific hot air (steam) drying equipment can dry wood of various species, sizes, and uses, featuring high efficiency, energy saving, safety, reliability, short cycles, high quality, and low costs. It is widely used in wood processing enterprises, particularly suitable for wood product export companies. During normal operation, the fuel is fully combusted in the combustion chamber, generating high-temperature air through the heat exchange system. This hot air is then circulated by the fan and delivered through the control pipeline system to the drying room, where it dries the wood. Simultaneously, the steam generation system produces a large amount of atmospheric steam, which is sent into the drying room through the control pipeline system according to the drying process requirements, for steam injection and humidity adjustment treatment. Saturated steam can make the moisture content inside and outside the wood consistent in a short time, thereby alleviating the residual stress in the wood. Moreover, for solid and thick wood, our company's pressure intermittent heating drying process can be used, which solves the defects such as internal cracking, end cracking, and deformation that occur during the drying process, greatly improving the yield of finished wood products. Additionally, it is equipped with a secondary heat utilization system, which maximizes the reduction of heat loss caused by moisture discharge, significantly lowering the drying cost and shortening the drying cycle. When the moisture content of the wood is below 15%, all the wood-boring insects and eggs within the wood can be completely killed after 6-8 hours of high-temperature dry steam treatment.
Control Systems and Functions:
The JLM.JLK series of drying equipment is equipped with adjustable combustion aids inside the combustion chamber, adjustable control devices at the beginning of the chimney, adjustable steam喷射 devices at the beginning of the air duct, and comes with an automatic temperature display instrument and a humidity sensor. With these configurations, operators can control and monitor the temperature and humidity inside the drying chamber according to the drying process requirements, ensuring maximum drying of wood.
The control system can be fully automatic or manually controlled. In large ovens, top-mounted and side-mounted circulation fans can be added according to customer requirements to further enhance the flow of indoor hot air.
Features of Diesel-Electric Combination Drying Equipment:
Multi-band automatic temperature control, high-temperature alarm, humidification, dehumidification, timed on/off, suitable for secondary wood drying, balancing wood moisture content.
2. Fast heating, even heat distribution, low energy loss, easy to assemble and disassemble, and convenient for moving. Suitable for rental factories and wood processing enterprises.
3. Dual-fuel with both wood and electricity; uses low-voltage electricity at night for cost-effectiveness, and burns wood during the day for further reduced prices - a win-win solution.
































